Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Active Tutors
Asked Questions
Answered Questions
Design a 2-digit 24 second 'shot-clock' countdown timer with pushbutton controller. The pushbutton controller will have one input: (IN) and provide two outputs: CNT and RST for count and reset respe
The objective of the project is to protect damage of the DC motors. If the motor is not working it will be shown with red light, if working normally then green and if working at a slow speed then it
Draw graphs comprising algebraic, trigonometric and logarithmic data from a range of scientific and engineering sources, and find out realistic estimates for variables by using graphical estimation
In this assignment, you will examine the low-carbon technology which would be most suitable to give heat and power for a domestic building.
In the given circuit, find out the current and voltage in each resistor using Ohm’s Law and KVL.
Simplify the block diagram shown in figure below and obtain the overall transfer function. (You have to use various commands in MATLAB that will help to simplify)
Figure below shows a pneumatic circuit in which four actuators are controlled.
Interpret manufacturer’s data sheet to select appropriate combinational logic devices for specific purposes.
The mobility of the electrons through a separate experiment was found to be 100 x 10-4 m2/V-S. Find the electron concentration in this material.
Use MATLAB and design following FIR filters. Plot their magnitude and phase responses.
Design digital filters to remove/reduce un-wanted noise from a desired signal. Using MATLAB, provide plots of the “clean” and “noisy” ECG signals. Design FIR filters.
A heated object is allowed to cool in a room temperature which has a constant temperature of T0.
Implementing Kalman fillter, Suppose xi is a state-scalar that admits the following recursion (so-called the first-order Gauss-Markov process): xi+1 = 0.9xi + ni
Describe “What are path loss and shadowing in wireless propagation?” In the description, please explain the reasons of these two phenomenons and the impact of these phenomenons on wirele
Apply nodal analysis to find i0 and the power dissipated in each resistor in the circuit.
Use Laplace transforms for the transient analysis of networks. Compute circuit responses to a step input in practical situations.
Design a suitable phase-lead controller. You should explain in detail how your design has been developed. Your solution should include Bode plots constructed both manually and using an appropriate p
The three-phase 50 Hz synchronous generator is operating at unity power factor, with following conditions: line-line voltage 13kV, stator current 1000A, field current 80A, torque angle 20°.Determine
Briefly describe why an electronic soft starter is becoming much popular to limit the starting current of an induction motor.
Build the model in MATLAB/Simulink and simulate the feasibility of the Battery SOC estimation algorithm using Kalman filtering method.
Improve on an undamped control system in order for it to exhibit a stable response and investigate and report upon the use of control in improving a system's response.
The objective of this project is to design a visual search algorithm (VSA) that looks for an object in a video clip. The VSA takes in an image and a video as input, where the image contains an objec
Way to stop audible alarm is to input the correct PIN. If correct PIN is input, the alarm system is de-activated, and becomes dormant (ready for further burglar detections). If incorrect PIN is ente
Consider the noise cancellation system described below. The useful signal is a sinusoid s(n) = cos (wo n + Φ), wo = Π/12 where the phase Φ is a random variable uniformly distributed from
Consider the effect of adding capacitor banks in two stages, each drawing 200 kVAr leading. Calculate the power factor and the apparent power.