Start Discovering Solved Questions and Your Course Assignments
Propose a simple controller system that would operate this pedestrian system process using the Mooreor Mealy approach
Objectives: i) To study quality measurement parameters ii) To study the electrical characteristics of Light Emitting Diode (LED)
What is the advantage of monitoring winding temperature as a method of overload protection? Name two other types of overcurrent protection.
With reference to the phasor diagram, state what is meant by the load angle of a synchronous motor. What is the value of angle when motor runs on no-load?
Express the intrinsic impedance, phase velocity, and the wavelength. Calculate the instantaneous electrical and magnetic fields
UFMFJN-15-3 Radio Frequency and Microwave Circuit Design: Apply concepts underlying the design of RF and microwave circuits.
Unit 22 Electronic Circuits & Devices: Investigate the types and effects of feedback on an amplifier's performance.
Unit 22 Electronic Circuits & Devices: Apply testing procedures to electronic devices and circuits.
Provide a report the assesses the performance characteristics of various types of oscillators, including their applications.
ELEC 10004 Electronic Circuits: Classify various applications of pn-junction diode. Indicate the BJT biasing circuits.
ELEC 10003 DC Electrical Circuit Analysis: Describe the concepts of voltage, current and resistance for simple dc circuits.
F/615/1496: Electronic Circuits and Devices: Determine the operational characteristics of amplifier circuits.
i) Simulate a zero-span circuit ii) Simulate its Interfacing with Arduino iii) Design a suitable Printed Circuit Board
State the formula for determining the synchronous speed of an induction motor. Define the term 'slip' as applied to an induction motor.
Briefly explains the difference between intrinsic and extrinsic semiconductor. Determine the biasing conditions of diodes D1 and D2.
You are required to carry out a comparative review of existing software tools for the modelling and optimisation of the configuration of microgrids.
ENG5031 Fault Detection, Isolation and Recovery: Construct an event tree diagram based on the description of the CHP system in Figure Q1
This is a problem for writing an FDTD code and understanding various numerical aspects related to FDTD simulations.
UFMFLN-15-3 Satellite Communications: Apply skills required to design an end-to-end satellite communications link budget.
Design and build a system that can measure the voltage and current supplied to a battery by a charge controller driven by a PV panel
INSTR F244 Microelectronic Circuits: Obtain the Gain margin and phase margin. Plot the variation of differential mode gain when VDD varies by ±10%.
The aim of this project is to design, simulate and investigate a DC Power Supply has the following specifications:
Schematic of a gear box between the motor and the load is shown in Figure Q1. N1 and N2 are the number of teeth in each gear wheel.
Calculate the DC bias voltages (V(c_1), V(c_2), V(E_2), V(B_1), V(CE_2)) and currents (I(B_1), I(c_2), I(E_2 )) for Darlington configuration
Discuss the damage done producing batteries, the fact that power for electric cars often comes from fossil fuels.