Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Solved Assignments
Asked Questions
Answered Questions
Determine the value of the constant c such that the following functions are valid probability functions: A. p(x) = cx/20, x = 1,2,3,4,5,6 and zero elswhere. B. p(x) = c(X^2 + 1), x = 1,2,3,4,5, and ze
A p-type wafer has a diffused Phosphorous n-type junction with a junction depth of 0.15µm. a) If the wafer (no pre-existing oxide) is to be oxidized at 1000 C for two hours to form a ‘dens
The lithographic system A uses KrF excimer laser source (248 nm) while the lithographic system B uses the I-line of a Hg lamp (365 nm) as the photon source. Give two main shortcomings of the e-beam
For w=w0, compute the ratio of the amplitude of the voltage source over the amplitude of the voltage across the resistor,Q=|U|/V0, when V0=sqrt(2), C=8.2microF, L=7mH, and R=1.5kOhms. Is this ratio la
A transistor current source (also known as current ''sink'') was built with a 2N3904. The Ic was measured for different values of a load resistance. It was noticed that Ic was pretty much constant f
1. Calculate the Fourier transform of f(t)=5 sinc ([t-0.2]/2), and graph the magnitude and phase as function of f. 2. A military satellite uses 10 GHz for the downlink frequency. The distance to the s
The space between the plates of a parallel-plate capacitor is filled with a dielectric whose permittivity varies linearly from f1 at one plate (located at y=0) to f2 at the other plate (located at y
A potentiometer is wired is wired to represent a rotational range of 0-180 degree. The potentiometer is supplied with a voltage of 15 VDC. What is the output voltage at 75 degree
If a logic circuit with I_OH = 4.5 V is driving and LED with a 330 ohm limiting resistor, what is the current rating for the LED if the forward voltage drop is 1.8 V
state the probability distribution of the binomial random variable X. What is the probability that the random variable X falls in the interval [u - 3 sigma, u + 3 sigma]. The mean and the variance o
A charged 100- picoFarad capacitor has initial voltage across it of 10 V. A 100 kohm resistor is suddenly connected across the capacitor (at t=0) to discharge it. What is the magnitude of the inst
(a) find the value of a and K so that the relative damping ratio of the system is 0.5 and the rise time step response is approximately 1 s. (b) with the values of a and k found in previous question
Consider a Si p-n junction at room temperature. If the doping concentrations are NA=1016 cm-3 and ND=1015 cm-3, what is the depletion width also known as space charge width Also find the maximum ele
Two batteries with 1.8 voltage and 10.5 Ohm internal resistance each are connected in series. This battery pack is used to boot a small electric motor with 275 Ohm resistance. Find the power delive
Write a simple shell script called mathmagic that takes two arguments in at call time and returns to the stdout the value of the two items entered, the value of the two items added together, the val
When disconnected and fully charged, the voltage across the battery terminals is measured to be 13.8 V. When connected to a load that dissipates 18 W of power, the terminal voltage of the battery de
A shunt regulator utilizing a zener diode is biased on through a 100ohm resistor. Determine the change in the regulated output voltage for the two situations below a) VI changes +2.0 V, ILoad consta
A discrete-time signal x[n] is periodic with period 8. One period of its DFT harmonic function is {X[0],...,X[7]}={3,4+ j5,- 4 - j3,1+ j5,- 4,1- j5,- 4 + j3,4 - j5}. (a) What is the average value of x
Refer to the Wheatstone Bridge diagram. If R1=1ohm, R2=111ohm, Runknown= 1ohm, R3 is set at 1Kohm, and the battery is 9V:What is the current flowing through the galvanometerohm Use 60ohm for the int
The switch in the circuit has been in position a for a long time. At t=0 the switch is moved to position b. A.Calculate the initial voltage on the capacitor if v = 200V , and i = 1.9mA.
Determine the ROM size and contents to implement a function which converts a sign and magnitude number from -5 to +6 to two's complement format.
Given the following function: F(W,X,Y,Z) = fm(2,3,5,7,12,13). a. Implement the function using an 8-input multiplexer. b. Implement the function using a 4-input multiplexer.
What is the data rate of a digital electrical communication system that uses 16 voltage levels to carry multiple bits with one voltage level, where each voltage level is kept at that level for a dur
3-singlephase 2 winding transformers, each rated 500 MVA, 13.8/199.2 kV, with leakage reactance Xeq = 0.10 per unit, are connected to form a three-phase bank. Winding resistances and exciting curren
1-phase 2-winding transformer is rated 30 kVA, 360/90 V, 60 Hz. A source connected to the 360-V winding supplies an impedance load connected to the 120-V winding. The load absorbs 15 kVA at 0.8 p.f.