What is the time spent in the listening and learning states

Question 1. Which of the following best describes the mapping between VLANs and IP subnets in a modern switched network?

One VLAN to many IP subnets

One IP subnet to one VLAN

One IP subnet to many VLANs

Varies with the model of Cisco Catalyst switch

Question 2. Which of following VLAN frame encapsulation types are configurable on a Cisco switch?




None of the above

Question 3. Which of the following depicts a VTP domain?

Switches share VLAN information; the boundary is defined by a Layer 3 device.

It can only create, delete, and modify local VLANs.

It advertises VLAN configuration information and can create, delete, and modify VLANs.

It restricts broadcast traffic to those trunks that must be used to reach the destination devices.

Question 4. A _____ stores VLAN information only in RAM.

VTP client

VTP domain

VTP pruning

VTP server

Question 5. Which VTP mode should a Cisco switch be set to if this switch is to add or delete VLANs to a management domain?





Question 6. Which of the following is the closest to the root bridge?

Root port

Spanning Tree Protocol

Spanning-tree algorithm

Switch diameter

Question 7. What is the time spent in the listening and learning states called?

Forward delay

Forwarding state

Hello time

Learning state

Question 8. The time between each BPDU sent on a port is called which of the following?

Forwarding state

Hello time

Learning state

Listening state

Question 9. A term for when the port is administratively shut down is _____.

designated ports

disabled state

forward delay

forwarding state

Question 10. In the _____ state, the MAC address table is built but does forward user data frames.


hello time



Question 11. Which contains a priority value and the MAC address?

Bridge priority

Bridge protocol data unit

Designated ports

Bridge ID

Question 12. VLAN is a logical group of ports, usually belonging to _____ to control the size of the broadcast domain.

a single IP subnet

multiple IP subnets

either a single IP subnet or to multiple IP subnets

none of the above

Question 13. Which command is used to determine whether inter-VLAN communication is functioning?

show vlan



show interface

Question 14. Inter-VLAN routing _____ additional subnet broadcast addresses.


does not require

sometimes requires

none of the above

Question 15. How many physical interfaces are required to perform inter-VLAN routing with traditional inter-VLAN routing?

One port per VLAN

Two ports per VLAN

Four ports per VLAN

No physical interface per VLAN.

Request for Solution File

Ask an Expert for Answer!!
Computer Networking: What is the time spent in the listening and learning states
Reference No:- TGS01084975

Expected delivery within 24 Hours