Start Discovering Solved Questions and Your Course Assignments
TextBooks Included
Solved Assignments
Asked Questions
Answered Questions
Design the general components of the hydraulic system, displaying several components.
Describe CB configuration for the transistor. Draw family of CB output characteristics for the transistor.
Draw the truth table for full adder also sketch the suitable logic circuit. Describe it in detail.
Sketch a neat diagram of cotter joint and state different strength equations for its full design.
Describe the “Stress Concentration”. Explain the term Resilience.
Describe what sweep and extrusion method for the geometric modelling is?
Describe the phenomenon of CSG modelling.
Write down the advantages of outsourcing an information system.
Write a detailed note on business software solutions provided by Oracle.
Write the comparisons of higher and lower pair on basis of nature of contact.
Explain the working of scotch yoke mechanism with suitable diagram?
Describe the working of cylindrical parabolic concentrating collector.
Explain the working of solar water heater with the appropriate diagram.
Write differences between END milling and FACE milling operations?
List the taper turning method on lathe. Explain any one of them.
Sketch the labelled V-I characteristics of UJT. Describe the peak point and the valley point.
Design the frequency response for RC coupled, transformer coupled and directly coupled amplifiers.
Write comparison between venturimeter and orificemeter.
Explain the term guage and the absolute pressure.
Explain the requirements of the pulse to trigger the SCR successfully.
Specify four modes of operation of the TRIAC. Describe any one mode with the help of neat and labelled diagram.
Illustrate the aim of code optimization phase in the compiler? Describe the local optimization.
Compare and contrast two-pass assembler with a single pass assembler. Explain how are forward references handled in one-pass assembler?
Specify the factors that are affecting the capacitance of capacitor.