--%>
Assignment Help - homework help

What is regenerative braking

Explain the term regenerative braking?

E

Expert

Verified

Whenever the supply is not available for the running motor, it will still continue running because of inertia. To stop it rapidly we need to place the load across armature winding and motor must have managed continuous field supply so that back e.m.f voltage is formed to apply across resistor and because of load motor stops rapidly.  Such type of breaking is said to be Regenerative Breaking.

   Related Questions in Electrical Engineering

  • Q : Illustrates the Validating Requirements

    Illustrates the Validating Requirements in embedded system?

    		•
  • Q : What do you mean by the term

    What do you mean by the term demodulation?

    		•
  • Q : Determine expressions for the output HI

    Draw an estimated input-output transfer characteristic for the loaded inverter circuit demonstrated below. Determine expressions for the output HI and LO logic voltages as well as the critical maximum input logic LO voltage ViL max. Obtain an expression for

    		•
  • Q : KDD and steps involved in KDD process

    Explain the term KDD. Write down the steps that are involved in KDD process.

    		•
  • Q : Estimate your personal Annual Energy

    Estimate your personal Annual Energy Usage for the following - list all data in kWh (KiloWatt hours): Space Heating (Central heating, room heaters etc.- if you share a central system, e.g. in a flat or Hall, estimate your personal use). Space cooling (if you have air condi

    		•
  • Q : Linear phase characteristic of FIR

    Explain the essential and adequate condition required for the linear phase characteristic of the FIR filter? List the well known technique for designing the linear phase FIR filter?

    		•
  • Q : Estimate the current flowing from

    A bipolar junction diode contain a uniform cross-sectional region of 2x10-3 cm2 and a doping concentration of 1013 cm-3 in p-type and n-type both materials.  Therefore diffusion properties are Dn = 5 cm2s-1, Ln = 50 µm for (e-

    		•
  • Q : Error correcting methods Specify the

    Specify the types of error correcting methods.

    		•
  • Q : Find out doping concentration to

    A bipolar junction diode is to be fabricated consisting of the p-type material hundred times further heavily doped than the n-type material. Find out the doping concentration needs so as to acquire a barrier potential of V0 = -0.5V on a temperature of 300oK.

  • Q : Answering some questions hi, read that

    hi, read that questions that i attached, could you answer all of them.

    		•