--%>
Assignment Help - homework help

Control and Observation points

Explain some of the examples of good candidates for control and observation  points.

E

Expert

Verified

Examples of good candidates for control points are as follows:

a) Control lines to tri state devices

b) Data select lines to multiplexers and de-multiplexers

c) Enable read/write inputs to the memory devices

d) Enable/hold inputs to the microprocessors.

Some of the examples of good candidates for the observation points are as follows:

a) Global feedback paths.

b) Redundant signal lines.

c) Stem lines associated with signals having high fan-outs.

d) Address, control, and data buses.

   Related Questions in Electrical Engineering

  • Q : Estimate voltage- current - optimum

    Make a Thevenin Equivalent Model for the given circuit demonstrated in below. Therefore, find out the optimum value of load resistance that will maximise the power delivered to the load. Estimate the voltage across and the current by the load resistance i.e. RL, and t

    		•
  • Q : Power plant Draw feed water heating

    Draw feed water heating system in thermal power plant

    		•
  • Q : Problem on combinational logic design

    Design and analysis of an IC adder built using discrete  logic and a dedicated adder using Integrated Circuits  a) Design a full adder using logic gates. In the design process show truth tables, karnaugh maps and other material used to derive the

    		•
  • Q : Illustrates the functions of memory

    Illustrates the functions of memory?

    		•
  • Q : Types of Transparencies Explain the

    Explain the various types of Transparencies?

    		•
  • Q : Difference between the Latches and Flip

    Write down the fundamental difference between the Latches and Flip flops? 

    		•
  • Q : Control and Observation points Explain

    Explain some of the examples of good candidates for control and observation  points.

    		•
  • Q : Meaning of FIR filter Explain the

    Explain the meaning of the FIR filter?

    		•
  • Q : Problem on electric power The sketch

    The sketch illustrates a common consumer product termed as Water Pik. This device uses a motor to drive a piston pump that produces a jet of water (diameter d = 3 mm, temperature T = 10 °C) with a speed of 25 m/s. Find out the minimum electric power in watts which is needed by the device.

    		•
  • Q : Define Cogeneration Cogeneration is a

    Cogeneration is a very high efficiency energy system which generates both electricity (or mechanical energy) and valuable heat from the single fuel source. Cogeneration is some times termed as combined heat and not only produces power however also giv

    		•