--%>

Benefits and drawbacks of ECL

Write down the benefits and drawbacks of ECL?

E

Expert

Verified

Advantages are listed down as follows:

a) The speed increases.

b) Propogation delay is 1 (or) 2 nanoseconds.

Disadvantages are listed as follows:

a) Noise immunity is very very low.

   Related Questions in Electrical Engineering

  • Q : Find out the minimum value of the base

    Obtain an expression for the fan-out F of the loaded a particular transistor inverter stage demonstrated below in terms of the minimum input logic HI voltage ViH min and another circuit parameters (don't form a substitution for ViH min into the derivation). While

  • Q : Find out voltage across and current by

    Determine a Thevenin and a Norton Equivalent Model for the circuit demonstrated in figure given below. Find out, using the models, the voltage across and the current by the load resistance that is RL, and the power consumed through the load. Verify both models present

  • Q : Delay and Phase distortion Explain how

    Explain how the delay distortion and phase distortion are introduced?

  • Q : Objectives for incident reports Explain

    Explain the valid objectives for the incident reports?

  • Q : Networking Homework Help >> Question >>

    Homework Help >> Question >> Address allocation and flow mapping assignment Any questions that are completed should be explained and given a general reason to why that strategy was used. Address allocation is already done and flow mapping is already completed. I just need Q2, Q4, Q5, Q6, Q7, Q8,

  • Q : Software tools in designing embedded

    explain the software tools in designing an embedded system

  • Q : EMBEDDED SYSTEMS EXPLAIN THE

    EXPLAIN THE CHARACTERISTICS OF EMBEDDED SYSTEMS

  • Q : Use of Decision table testing Explain

    Explain the situation when Decision table testing is utilized?

  • Q : Calculate the current needed to feed

    A coil having of 6,000 turns is wound upon a former of length 12cm and diameter 3cm that has a wax core having a relative permeability of 1,500. The coil should produce a total magnetic flux of 0.1 Wb. Calculate the current needed to feed the coil.

  • Q : Benefits of ARCHIVELOG mode and NO

    What are the benefits of operating a database in ARCHIVELOG mode over operating this in NO ARCHIVELOG mode? Answer: Whole database recovery from disk failure is prob