--%>
Assignment Help - homework help

Gasoline in Diesel Engine

If the gasoline is used in the Diesel engine explain whether the Diesel engine will work?

E

Expert

Verified

No the diesel engine, will not work since Compression ratio of Petrol the engine is 6 to 10 & also of the Diesel engine is 15 to 22. Therefore, on such high compression, gasoline will get highly compressed & it can blast also.

   Related Questions in Mechanical Engineering

  • Q : Efficient design What is meant by ‘

    What is meant by ‘efficient design’? Explain.

    		•
  • Q : Problem on work of compression A diesel

    A diesel engine operates devoid of a spark plug by using the high-temperature gas produced throughout the compression stage to ignite the fuel. During a typical compression, pure air that is originally at 21 °C and 0.95 bar is reversibly and adiabatically compress

    		•
  • Q : Stop cooling-water flow in turbine

    Whether you stop cooling-water flow through steam condenser when the turbine is slopped?

    		•
  • Q : Working environment in Product design

    Working environment: The conditions under which the product is likely to be used, stored, and transported must be specified. The product may have to operate in conditions of extreme temperature, be subject to vibration, radiation; these conditions wil

    		•
  • Q : Radial bearings Explain the importance

    Explain the importance to remember about the radial bearings?

    		•
  • Q : Problem on mechanical efficiency of the

    The oil pump is drawing 25 kW of electric power while pumping oil with ρ = 860 kg/m3 at a rate of 0.1 m3/s. The inlet and outlet diameters of the pipe are of 8 cm and 12 cm, respectively. When the pressure rise of oil in the pump is measured to be 250 k

    		•
  • Q : Problem on discharge of water In the

    In the below system, d = 6 in., D = 12 in., Δz1 = 6 ft, and Δz2 = 12 ft. The discharge of water in the given system is 10 cfs. Is the machine a turbine or a pump ? Determine the pressures at points A and B? Neglect head losses. Suppos

    		•
  • Q : Difference between mill and mill-drill

    Difference between mill and mill-drill: Nowadays numerous manufactures are combining machines; a mill-drill is one of such. This is a combination of a drill and a mill, a mill eliminates stock from material (genera

    		•
  • Q : Ergonomics in product design

    Ergonomics: This is concerned with how easy (comfort, complexity) the product is to use by the targeted market. Physical human dimensions must be considered when designing the driver's seating, instruments, and controls in a car. Slight variations bet

    		•
  • Q : Quantity in Product design specification

    Quantity: The total quantity of the product predicted and, more importantly, the production rates and batch sizes needed, should be specified. This will have implications for the types of manufacturing equipment and work organization necessary. It wil

    		•