--%>

Define Product Design Specification

Product Design Specification: Once the basic idea for a product has been made, the next step is to create a product design specification, or PDS. This document must be as comprehensive and as detailed as possible as it forms the basis of all the work that is to follow. The PDS states the „boundary conditions? within which the design must be created. Some examples of the factors in a PDS are:

  • Conformance to standards and specifications
  • Product appearance
  • Product performance
  • Life expectancy
  • Maintenance
  • Working environment
  • Quantity
  • Size and weight
  • Ergonomics
  • Safety

   Related Questions in Mechanical Engineering

  • Q : Problem on displacement response time

    (i) Formulate the equation of motion for the system shown in Figure below. List two assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The system begins with the displacement of 5 cm and velocity

  • Q : Size and weight in Product design

    Size and weight: If the product is particularly small the cost may be increased if more precise manufacturing methods are demanded. Weight restriction will as well influence materials to be utilized: this in turn will influence the manufacturing proce

  • Q : Problem on Ideal gas process A) Air at

    A) Air at 4MPa and 3000C enters a will insulated turbine operating at steady state with negligible velocity. The air expands to an exit pressure of 100KPa. The exit velocity and temperature are 90 m/s and 1000C respectively. The diameter of the e

  • Q : How do you repair a hydraulic jack How

    How do you repair a hydraulic jack?

  • Q : Problem on mechanical efficiency of the

    The oil pump is drawing 25 kW of electric power while pumping oil with ρ = 860 kg/m3 at a rate of 0.1 m3/s. The inlet and outlet diameters of the pipe are of 8 cm and 12 cm, respectively. When the pressure rise of oil in the pump is measured to be 250 k

  • Q : What is Cotter joint Cotter joint :

    Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both

  • Q : Define spinning jenny Spinning jenny:

    Spinning jenny: It is a multi-spool spinning wheel. It was invented in the year 1764 by James Hargreaves in Stanhill, close to Blackburn, Lancashire in the north west of England (though Thomas Highs is another candidate recognized as inventor).

  • Q : Difference between PLC and Logic Card

    Difference between PLC and Logic Card: There is technically no difference. Both are logic controller utilized for several applications and in PLC has it's own internal memory (compared to Logic card).

  • Q : Define feasibility study Feasibility

    Feasibility study: In order to take wise investments in a market-place experiencing rising stages of risk, companies are turning to feasibility studies to find out if they must propose new products, services or commence a new business endeavor. The ma

  • Q : Bearing number ti Diameter of inner and

    Specify how the Bearing number ti Diameter of the inner and outer can be calculated?