Practical Design Example The tall building in Figure is constructed of structural steel.
The exterior columns, which are uninsulated, are exposed to the outside ambient temperature. To reduce the differential vertical displacements between the interior and exterior columns due to temperature differences between the interior and exterior of the building, a bonnet truss has been added at the top of the building.
For example, if a bonnet truss was not used to restrain the outer columns from shortening in the winter due to a 60°F temperature difference between the interior and exterior columns, points D and F at the top of the exterior columns would move downward 1.68 inches relative to the top of the interior column at point E.
Displacements ofthis magnitude in the upper stories would produce excessive slope of the floor and would damage the exterior facade. If the temperature of interior column BE is 70°F at all times but the temperature of the exterior columns in winter drops to 10°F, determine
(a) the forces created in the columns and the truss bars by the temperature differences and
(b) the vertical displacements of the tops of the columns at points D and E. Slotted truss connections at D and F have been designed to act as rollers and transmit vertical force only, and the connection at E is designed to act as a pin.
The shear connections between the beam webs and the columns may be assumed to act as hinges. Given: E = 29,000 kips/in2.
The average area of the iIl.terior column is 42 in2" and 30 in2 for the exterior columns.
The areas of all members of the truss are 20 in2. The coefficient of temperature expansion . a == 6.5' x 10-6 (inlin)/°F.
Note: The interior columns must be designed for both the floor loads" and the" cqrnpression force created by the temperature differential
