Compare the calculated and measured values in the table and

Question

Electronics Lab Assignment: Transistor Fundamentals

Introduction:

Lab is based on the fundamentals of a transistor and analysis of an analog circuit.

Review the following videos before getting started with this lab:

1. Watch the video: "Video 3: Fundamentals of breadboard"
2. Watch the video: "Video 4: Basic electrical components"
3. Watch the video: "Video 5: Simple resistive circuit with NI myDAQ"

Materials and Equipment:

Materials:

• Hardware Parts (In the Toolbox):

o An NPN transistor: 2N3904
o Two resistors: 10 kΩ and 3.6 kΩ
o Jumper wires

Equipment:

• Hardware Equipment:

o Breadboard
o NI myDAQ Instrument device
o Screw Driver
o Screw Terminal connector
o USB Cable
o Multimeter probes
o Oscilloscope, Multimeter and Function generator from NI ELVISmx Intrument Launcher

Procedure:

*** This lab has to be implemented only in hardware (using NI myDAQ) ***

1. Analyze the circuit in the Figure 1 below to calculate the following values: V_E, I_E, V_RC, V_C, V_CE. Make sure to include 20% tolerance for each resistor in the calculations.

2. Construct the circuit shown in Figure 1 below on the breadboard using the transistor and two resistors (R_Cand R_E).

3. Using the jumper wires, screw driver and screw terminal connector, connect the board to NI MyDAQ Instrument Device.

4. Use channel +15V pin out on the NI myDAQ Instrument Device to provide the supply voltage (V_CC) and channel AO0 to provide the base voltage (V_BB). Make sure that this voltage is peak-to-peak. Use channel AI0 to measure the required voltages using the oscilloscope.

Figure 1

5. Using the function generator from NI ELVISmx Instrument Launcher, provide the input voltage V_BB to the circuit.

6. Use the oscilloscope to measure the voltages: V_E, V_RC, V_C, V_CE.

7. Now, using multimeter with the probes, measure the required voltages: V_E, V_RC, V_C, V_CE and currents: I_C and I_E.

8. Tabulate the values obtained in step 1 and 7.

	Calculated	Measured
VE
IE
VRC
VC
VCE

Review questions:

1. Compare the calculated and measured values in the table and analyze the performance of the transistor.

2. Discuss whether the values are the same or different. If they are different, provide the reasoning and explain how to reduce this difference between calculated and measured values.

3. Explain what happens when the transistor changes to a PNP transistor. How does the change in the transistor effect the current and voltage in the circuit?

Deliverables:

1. Analysis of the circuit and calculations of voltages: V_E, V_RC, V_C, V_CE and currents: I_C and I_E.

2. Place your student ID card on the breadboard and take a picture of the circuit board and pin out on the NI myDAQ Instrument Device.

3. Take screenshots of the measurements obtained from function generator and Multimeter on the NI ELVISmx Instrument Launcher on your screen.

Attachment:- Lab-Report-Template.rar