--%>
Assignment Help - homework help

Rated Speed and Economic Speed

Explain difference between the Rated Speed and Economic Speed?

E

Expert

Verified

The rated speed tells us about the maximum speed which can be achieved by a vehicle or some other machine but the economical speed means the speed limit at which the machine works efficiently with least consumption of fuel.eg-in normal bikes(not racing),the max.speed limit shown on speedometer is upto 120 kmph but companies always advice their customers to drive such bikes at around 60 kmph to have maximum mileage.

   Related Questions in Mechanical Engineering

  • Q : High Discharge pump Why Centrifugal

    Why Centrifugal Pump is known as the High Discharge pump?

    		•
  • Q : Powder Technology Explain the term

    Explain the term Powder Technology?

    		•
  • Q : What is Cotter joint Cotter joint :

    Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both

    		•
  • Q : Synchronous generator & Generating units

    Question 1: Three generating units operating in parallel at 60 Hz have rating of 300, 500, and 600    MW and have speed-droop characteristics of 5, 4, and 3%, respectively. Due to a change in load, a

    		•
  • Q : Problem on work of compression A diesel

    A diesel engine operates devoid of a spark plug by using the high-temperature gas produced throughout the compression stage to ignite the fuel. During a typical compression, pure air that is originally at 21 °C and 0.95 bar is reversibly and adiabatically compress

    		•
  • Q : Efficient use of waste heat and

    Efficient use of waste heat and renewable heat sources 1. Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) and (b) a process warm water stream (e.

    		•
  • Q : Cavitation elimination by Pump How

    How Cavitation is eliminated by the Pump?

    		•
  • Q : Formation of Cavitation Explain the

    Explain the reason behind formation of the Cavitation in the Centrifugal Pump and not in the Displacement Pump?

    		•
  • Q : Radial bearings Explain the importance

    Explain the importance to remember about the radial bearings?

    		•
  • Q : Difference between mill and mill-drill

    Difference between mill and mill-drill: Nowadays numerous manufactures are combining machines; a mill-drill is one of such. This is a combination of a drill and a mill, a mill eliminates stock from material (genera

    		•