--%>
Assignment Help - homework help

Problem on discharge head loss

Water is draining from the tank A to tank B. The elevation difference among the two tanks is 10 m. The pipe joining the two tanks has a sudden-expansion section as shown below. The cross-sectional area of the pipe from A is 8 cm2, and the area of the pipe from B is 25 cm2. Suppose the head loss comprises of two losses: due to the sudden-expansion section and due to flow into tank B. Find out the discharge between the two tanks.

1052_water drainage.jpg

   Related Questions in Mechanical Engineering

  • Q : Undamped single degree of freedom (a)

    (a) The response for an undamped single degree of freedom system under free vibration is given as where ωn is the natural frequency and A and B are unknown that can be determined from the initial conditions. The response 

    		•
  • Q : Bernoulli's equation From Bernoulli's

    From Bernoulli's equation we know that presure head + velocity head at inlet and outlet header is same. If so  what is ' W' then in the equation ?

    		•
  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Excitation of Modes in Fiber A

    A multimode fiber is used to couple light into a single mode fiber. Both fibers have the same total diameter. Explain the coupling. Use equations, MATLAB, etc. if necessary. If an LED is used to excite a single mode fiber, explain the coupling of light to the fiber? U

    		•
  • Q : Gasoline in Diesel Engine If the

    If the gasoline is used in the Diesel engine explain whether the Diesel engine will work?

    		•
  • Q : Benefits of gear drive Benefits of gear

    Benefits of gear drive: In general, gear drive is helpful for power transmission among two shafts, which are close to each other (at most at 1m distance). Additionally, it has maximum efficiency while transmitting power. It is resilient as compare to

    		•
  • Q : Servo drive What do you mean by Servo

    What do you mean by Servo drive and how mechatronic integration approach is improved by it.

    		•
  • Q : ANSYS - Finite Element Analysis Hello,

    Hello, is the following project possible.

    		•
  • Q : Cetane Number and Octane Number

    Describe the term Cetane Number and the Octane Number?

    		•
  • Q : Mode Superposition Method Define Mode

    Define Mode Superposition Method in brief?

    		•