--%>
Assignment Help - homework help

Find value of channel length modulation factor of transistor

An n-channel MOS transistor is functioned in the saturation region along with a drain-source voltage of 2V. While the drain source voltage is twice, while keeping the gate-source voltage constant then the drain current increases by 5percent. Find out the value of the channel length modulation factor, i.e., λ, of the transistor.

   Related Questions in Electrical Engineering

  • Q : What are the types of memories What are

    What are the types of memories?

    		•
  • Q : Calculate the maximum thickness of the

    Excess minority carriers are injected within a thin slice of doped semiconductor of uniform cross-sectional region and are permitted to diffuse across the material. There diffusion coefficient for the material is 50cm2s-1 as well as the minority

    		•
  • Q : Difference between the Latches and Flip

    Write down the fundamental difference between the Latches and Flip flops? 

    		•
  • Q : White noise and Autocorrelation Define

    Define the following term: a) White noise b) Autocorrelation

    		•
  • Q : USE OF ‘WASTE’ HEAT & RENEWABLE HEAT

    1.Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) (b) a process warm water stream (e.g. from a commercial dishwasher). Discuss any aspects of the streams that may influence your choice of heat recovery system. 2

    		•
  • Q : High speed TTL and low power TTL State

    State some of the differences between high speed TTL and low power TTL?

    		•
  • Q : Estimate diffusion current flowing from

    A piece of homogenous semiconductor material that is n-type of length 100µm as well as uniform cross-sectional area of 5x10-4 cm2 having a doping concentration of 1017cm-3. There a linear gradient of carrier concentrat

    		•
  • Q : States the term specification States

    States the term specification? Answer: Specification is a bridge in between Architect and Customer. Specification conveys the customer’s requirements. These re

    		•
  • Q : Determine expressions for the output HI

    Draw an estimated input-output transfer characteristic for the loaded inverter circuit demonstrated below. Determine expressions for the output HI and LO logic voltages as well as the critical maximum input logic LO voltage ViL max. Obtain an expression for

    		•
  • Q : Explain term meta-stability Explain the

    Explain the term meta-stability? When and why it may occur? Explain several ways in order to avoid this?

    		•