--%>
Assignment Help - homework help

Difference between mill and mill-drill

Difference between mill and mill-drill:

Nowadays numerous manufactures are combining machines; a mill-drill is one of such. This is a combination of a drill and a mill, a mill eliminates stock from material (generally metal, however not limited just to metal, it mainly depends on your application), you employ fluted cutters like end mills. The drill aspect of the machine is just which drills holes, with appropriate speed for the correct size drill.

   Related Questions in Mechanical Engineering

  • Q : Change of power in flow of kinetic

    Air at 20 m/s, 260 K, 75 kPa with 5 kg/s flows into a jet engine and it flows out at 500 m/s, 800 K, 75 kPa. What is the change (power) in flow of kinetic energy?

    		•
  • Q : Lubricating oil in turbines Except the

    Except the lubrication, explain the other two functions of the lubricating oil in some of the turbines?

    		•
  • Q : Synchronous generator & Generating units

    Question 1: Three generating units operating in parallel at 60 Hz have rating of 300, 500, and 600    MW and have speed-droop characteristics of 5, 4, and 3%, respectively. Due to a change in load, a

    		•
  • Q : Problem on head loss The pump

    The pump illustrated in the figure adds 20 kW of power to the flowing water. The only vital loss is that which takes place across the filter at the inlet of the pump. Find out the head loss for this filter. Note that the gage pressure upstream of the filter is negativ

    		•
  • Q : Problem on motion of the system (a) A

    (a) A plane moving at a constant velocity, V, crashes into a building as shown in figure below. Due to the design against plane crash of that building, neither major damage nor explosion occurs but the building vibrates after the crash. Assuming that the building can

    		•
  • Q : Problem on magnitude of force A

    A horizontal pipe of dimension 540 mm diameter carrying 0.6 m3/s splits into two horizontal pipes of 300 mm diameter with 60% of the flow and another of 150 mm diameter with 40% of the flow. Find out the magnitude and direction of the force

  • Q : Value Engineering The value engineering

    The value engineering method focuses on functional values, and aims to increase the difference between the cost and value of a product: by lowering cost and/or adding value. In many cases, the emphasis is simply on reducing costs, and the design effor

    		•
  • Q : What is pneumatic system Pneumatic

    Pneumatic system is a system which employs air to power something. For illustration, have you seen the tube systems at the bank drive-up tellers? Air is employed to push the tubes back and forth from the teller to customer.

    Q : Gasoline in Diesel Engine If the

    If the gasoline is used in the Diesel engine explain whether the Diesel engine will work?

    		•
  • Q : Maintenance in Product design

    Maintenance: How frequently and easily the product is to be maintained must be specified. A photocopier shouldn't require a service call from a technician just to add toner. If the product is to be maintenance free, then costs may be increased due to

    		•