--%>
Assignment Help - homework help

Problem on magnitude of force

A horizontal pipe of dimension 540 mm diameter carrying 0.6 m3/s splits into two horizontal pipes of 300 mm diameter with 60% of the flow and another of 150 mm diameter with 40% of the flow. Find out the magnitude and direction of the force on the anchor holding the pipe junction when the pressure gauge reads 70 kPa. Suppose there is no energy losses.

1366_energy loss.jpg

   Related Questions in Mechanical Engineering

  • Q : Mechanical Systems Reliability -

    Mechanical Systems Reliability, MP3701 Your assignment must be submitted electronically via eLe

    		•
  • Q : Ergonomics in product design

    Ergonomics: This is concerned with how easy (comfort, complexity) the product is to use by the targeted market. Physical human dimensions must be considered when designing the driver's seating, instruments, and controls in a car. Slight variations bet

    		•
  • Q : Servo drive What do you mean by Servo

    What do you mean by Servo drive and how mechatronic integration approach is improved by it.

    		•
  • Q : Dynamic model for the paper machine

    Explain and derive the Dynamic model for the paper machine headbox?

    		•
  • Q : Mechanical design for manufacturing A

    A stone quarry in a remote part of the world requires that stone blocks of 3 cubic feet in volume be moved up a 50 ft long ramp which is inclined at 30 degrees. Since the location is remote, the blocks must be moved usng human power. On a continuous basis, human power

    		•
  • Q : Unilateral and Bilateral Tolerance

    Explain difference between the Unilateral and Bilateral Tolerance?

    		•
  • Q : What is machine shop Machine shop : A

    Machine shop: A facility which employs machines to fabricate devices from stock raw materials or to change mechanisms based on given specifications. Also termed as "Back" Shops. The general machines in a machine sh

    		•
  • Q : Efficient use of waste heat and

    Efficient use of waste heat and renewable heat sources 1. Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) and (b) a process warm water stream (e.

    		•
  • Q : Excitation of Modes in Fiber A

    A multimode fiber is used to couple light into a single mode fiber. Both fibers have the same total diameter. Explain the coupling. Use equations, MATLAB, etc. if necessary. If an LED is used to excite a single mode fiber, explain the coupling of light to the fiber? U

    		•
  • Q : Problem on discharge head loss Water is

    Water is draining from the tank A to tank B. The elevation difference among the two tanks is 10 m. The pipe joining the two tanks has a sudden-expansion section as shown below. The cross-sectional area of the pipe from A is 8 cm2, and the area of the pipe f

    		•