--%>
Assignment Help - homework help

Deterministic and random signals

Explain what is meant by the term deterministic and random signals?

E

Expert

Verified

Deterministic Signal : Deterministic signal refers to the signal about which there exists no certainty with respect to its value at any time. Consequently, deterministic signals can also be modelled as completely specified functions of the time.

Random signal : Random signal refers to the signal about which there exists uncertainty before its actual occurrence. Such type of signal can be viewed as the group of signals with every signal within the ensemble which is having different wave forms. For example: the noise within the television or radio amplifier is an example of random signal.

   Related Questions in Electrical Engineering

  • Q : Explain about iterative algorithm

    Explain about iterative algorithm.

    		•
  • Q : Basic Neutralizer Control System See

    See the attachment Please write a report which includes:see the figures , and write3 pages 1) a short report that analyses the P&ID 2. A one paragraph introduction. 3. A paragraph about the process. 4. The instruments that are used (describe their tags following the slides). 5. Describe the co

    		•
  • Q : What do you mean by Lenz law What do

    What do you mean by Lenz law? Describe in brief.

    		•
  • Q : Find out impedance in form of phase and

    Find out the impedance of the network demonstrated below as considered by the voltage source, V1, while operating at a frequency of 50Hz. Illustrates this in the form of phase and magnitude. In addition, determine the current drawn from the source by the ne

    		•
  • Q : Find value of channel length modulation

    An n-channel MOS transistor is functioned in the saturation region along with a drain-source voltage of 2V. While the drain source voltage is twice, while keeping the gate-source voltage constant then the drain current increases by 5percent. Find out the value of the channel leng

    		•
  • Q : What is change sharing Explain the

    Explain the Charge Sharing? Specify the Charge Sharing problem during the sampling of the data from Bus?

    		•
  • Q : Full form of MIMO Write down the full

    Write down the full form of MIMO? Also describe it in detail.

    		•
  • Q : USE OF ‘WASTE’ HEAT & RENEWABLE HEAT

    1.Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) (b) a process warm water stream (e.g. from a commercial dishwasher). Discuss any aspects of the streams that may influence your choice of heat recovery system. 2

    		•
  • Q : Operating modes of 8279 Specify various

    Specify various operating modes of 8279?

    		•
  • Q : Find range of cancellation voltage A

    A pressure transducer having a Wheatstone bridge construction has the properties listed in the table below. The transducer is exited using a constant current source having an adjustable range and temperature coefficient. The zero pressure offset of the transducer must

    		•