--%>
Assignment Help - homework help

What do you mean by the term crosstalk

What do you mean by the term crosstalk?

E

Expert

Verified

Crosstalk is a form of interference which is caused by signals in close by conductors. The most common illustration is hearing an unwanted conversation on the telephone. Crosstalk can as well take place in radios, televisions, networking equipment and even in the electric guitars.

   Related Questions in Electrical Engineering

  • Q : Output of system with system function

    Specify output of system with system function H1 and H2 when connected in cascade and in parallel?

    		•
  • Q : Prove phase shift is similar at pole

    The steady state transfer function of the certain electrode amplifier interface model demonstrated below is specified as: 1564_ste</span></p> </div> <!-- /comment-box --> </li> </td> </tr><tr> <td> <li> <div class=

    Q : What do you mean by the term Biasing

    What do you mean by the term Biasing?

    		•
  • Q : Calculate the percentage change in the

    n-channel MOS transistors include the given properties:   Substrate Doping Concentration, NA= 2x1016 cm-3 Metal Fermi Potential, φFM = 0.6 V

  • Q : What is checksum What is meant by the

    What is meant by the term checksum?

    		•
  • Q : Alternative terms for data mining

    Provide some of the alternative terms for data mining.

    		•
  • Q : Find out the impedance of the series

    Find out the impedance of the series R-L network demonstrated in figure below at a frequency of 1 kHz and state this in the form of phase and magnitude. Calculate the current flowing in the network from the source and the individual voltages across the resistor and th

    		•
  • Q : Make a RLC network that have only two

    Replace the network demonstrated below, that operates at a frequency of 50Hz, along with an equivalent network containing only two passive elements.

    Q : Basic Column Control please see the

    please see the attachment. so, you can see figures. it helps you to write a report only 3 pages. write a short report that analyses the P&ID: i. A one-paragraph introduction. ii. A paragraph about the process. iii. The instruments that are used (describe their tags following the slides). iv.

    		•
  • Q : Calculate torque developed in pump and

    The motor within an automobile water pump draws a power of 10 Watt from the 12Volt battery. The permanent magnets of the stator produce a complete magnetic flux of 0.05Wb. The rotor former of a length of 8cm, a diameter of 5cm and the armature winding has 20 conductin

    		•