This assignment reures a packet tracer model. Is that capable?
Assignment: Setup a Network
Introduction
This is a two part assignment in which you will first set up a network that will then be used to build access lists.
Instructions
Begin by building the following network according to the specifications below:
- Use Cisco 2621 routers to build this network!
- Connect 3 routers using their serial interfaces; RT1 serial 0/0 to RT2 serial 0/0, RT2 serial 0/1 to RT3 serial 0/0. Use the 192.168.0.0/24 network and subnet it to address the serial links between the routers. Start with the first available subnet and then the next available subnet.
- On RT1's fa0/0 interface assign the 192.168.1.0/24 network, on RT1's fa0/1 interface assign the 192.168.2.0/24 network.
- On RT2's fa0/0 interface assign the 192.168.3.0/24 network, on RT2's fa0/1 interface assign the 192.168.4.0/24 network.
- On RT3's fa0/0 interface assign the 192.168.5.0/24 network, on RT3's fa0/1 interface assign the 192.168.6.0/24 network.
- Configure OSPF in area 0 to route all networks between the 3 routers.
Once you have built an OSPF network consisting of 3 routers, you are ready to move on to the next part of this assignment. Perform static packet filtering using an access list to restrict access from the networks on RT1's fa0/1 interface to RT3's network connected to its fa0/0 interface. Create the access lists and place them in the most efficient place to accomplish this task.