What kind of RC filter do you need? Design the RC filter. Be sure to use standard resistor and capacitor values and specify the tolerance. Show all work.
Construct the circuit using Multisim. Use the tolerances which you specified in your design.
Use the multifunction generator for the input and use both channels of the Tektronix virtual scope to display the input and output voltages.
Create a table of your input and output voltage at dc, 250 Hz, 500Hz, 750Hz, 1kHz, 5kHz, 10kHz, 50kHz, 100kHz. Measure additional frequency points in order to get a nice set of data for the drop off. Be sure to capture several screenshots of the Tektronix virtual scope.
Given the output voltage at dc, what is the voltage 3dB down? In other words, what is the output voltage at the 3dB point? You should calculate this.
Using your simulation, change the frequency of the input voltage until the output voltage is that associated with your 3dB point. What is the frequency of the signal? That is your critical frequency. Take a screenshot of the scope. Add these measurements to your table. Also, put in your report this frequency. What is this frequency called?
Questions:
Does your circuit attenuate the signal at high frequencies? What is the attenuation at 10kHz?
How does your measured -3dB frequency (fc) compare to your design critical frequency? Give some reasons why it is different.