Consider the heat exchanger of Example 2.15 with the open-loop transfer function
(a) Design a lead compensator that yields PM ≥ 45° and the maximum possible closed-loop bandwidth. (b) Design a PI compensator that yields PM ≥ 45° and the maximum possible closed-loop bandwidth.
Example 2.15
A heat exchanger is shown in Fig. 2.35. Steam enters the chamber through the controllable valve at the top, and cooler steam leaves at the bottom. There is a constant flow of water through the pipe that winds through the middle of the chamber so that it picks up heat from the steam. Find the differential equations that describe the dynamics of the measured water outflow temperature as a function of the area As of the steam-inlet control valve when open. The sensor that measures the water outflow temperature, being downstream from the exit temperature in the pipe, lags the temperature by td seconds. Solution. The temperature of the water in the pipe will vary continuously along the pipe as the heat flows from the steam to the water. The temperature of the steam will also reduce in the chamber as it passes over the maze of pipes. An accurate thermal model of this process is therefore quite involved because the actual heat transfer from the steam to the water will be proportional to the local temperatures of each fluid. For many control applications it is not necessary to have great accuracy because the feedback will correct for a considerable amount of error in the model. Therefore, it makes sense to combine the spatially varying temperatures into single temperatures Ts and Tw for the outflow steam and water temperatures, respectively. We then assume that the heat transfer from steam to water is proportional to the difference in these temperatures, as given by Eq. (2.62). There is also a flow of heat into the chamber from the inlet steam that depends on the steam flow rate and its temperature according to Eq. (2.65),
