Solve the following problems:
1. A water treatment plant uses a dual media filter. The twomedia used are:
a) Anthracite coal with effective diameter of 1.1 mm, porosity of 0.6, and shape factor of 0.5.
b) Sand with effective diameter of 0.5 mm, porosity of 0.45, and shape factorof 0.7.
The entire filter depth is 0.8 m with 0.5 and 0.3 meters of anthracite coal and sand respectively. Calculate the total head loss in theclean filter if the loading rate is 200 m3/m2.day and the operational temperature is100C.
2. A conventional surface water plant with coagulation, flocculation, sedimentation, and filtration produces a filtered water with a turbidity less than 0.3 NTU, pH 7 and temperature 10oC on a day when the peak hourly flow is 3.0 MGD. After filtration, the water is chlorinated in a baffled reservoir.
For the peak hourly flow rate, t10 is 90 minutes. What is the required disinfection for the removal of Giardia cysts of the filtered water if free chlorine is used? The raw water microorganism concentration is <1/100 L.
Note: According to regulations, the free residual chlorine in the water entering the distribution system cannot be less than 0.2 mg/L for more than 4 hours and a residual in the distribution system must be detectable in at least 95% of the samples tested each month.
3. The transmission main from the well field to the community is 2500 ft, the velocity of flow at peak pumping capacity is 3.5 fps, water temperature is 10oC, and pH is 7.5. If free chlorine residual is applied at the well field and is 0.5 mg/L entering the distribution system, what is the log inactivation of viruses?
4. As part of their proposed new research treatment plant, City of St. James is planning to use five banks of rapid sand filter after their sedimentation tanks. Each bank of sand filters has six filtersoperated in parallel. Each filter bed has a surface area of 3m X 2m. The design flow rate is 0.044 m3/second. If the design loading rate to the filter is 150 m3 /day. m2, calculate the following:
a) What total filter surface area should be provided and how many banks of filters need to be operational?
b) What is the loading rate when one filter is out of service?
Note: Experiments conducted with rapid sand filters at nearby water treatment plants have demonstrated that satisfactory water quality can be obtained with rates as high as 235 m3 /day. m2.
5. A groundwater contains the following constituents to be treated by the lime-soda process to the minimum hardness possible has the following characteristics:
CO2 = 62.0 mg/L HCO3- = 250.0 mg/L as CaCO3
Ca2+ = 80.00 mg/L Cl- = 35 mg/L
Mg2+ = 36.6 mg/L SO42- = 96.0 mg/L
Na+ = 23.0 mg/L
The facility is to treat 50 x 106 L/day of water from this source using lime-soda ash to reduce the hardness.
a) Determine the total hardness, carbonate hardness, and non-carbonate hardness in mg/L as CaCO3.
b) Determine the lime and soda-ash dosages for softening (units of kg/day). Assume that the lime is 90 percent CaO by weight and the soda ash is pure sodium carbonate.
6. A water treatment plant is processing 19,000 m3/day of water. A settling basin for Type- 2suspension will remove 100 percent of all particles which has a settling velocity of 0.75 m/hour.
The basin has an average depth of 3.5 meters and the weir overflow rate is 8m3/m.hour. Determine:
a) Dimensions of each basin;
b) Detention time,
c) Weirlength for each basin.
Assume there are 3 basins with a rectangular unit in which the length is 3 times the width.
7. A water treatment plant with an average flow of Q = 0.044 m3/second treats its water with alum (Al2 (SO4)3·14H2O) at a dose of 25 mg/L. Alum coagulation is used to reduce the concentration of natural organic matter and reduce the alkalinity of water according to the equation given below. Find the total mass of alkalinity consumed. Assume all alkalinity to be bicarbonate.
Al2(SO4)3 · 14H2O + 6HCO3- ⇔ 2Al(OH)3 (s) + 6CO2 + 14H2O + 3SO2-4