• Q : What is the maximum mass of water-released by heating....
    Chemistry :

    What is the maximum mass of water that can be released by heating a 8.904 g sample of nickel(II) sulfate heptahydrate?

  • Q : Calculate e ch3oh completely reacts at constant temperature....
    Chemistry :

    Calculate E when 770.0 g of CH3OH(g) completely reacts at a constant temperature of 300 K and constant pressure of 0.95 atm. R = 8.314 J/mol*K and R = 0.08206 atm*L/mol*K.

  • Q : Main purpose of scratching beaker wall....
    Chemistry :

    What is the main purpose of scratching beaker's wall during the synthesis of the complex?

  • Q : Plot ph values as a function of volumes of added koh....
    Chemistry :

    Plot pH values as a function of volumes of added KOH and suggest appropriate indicators for the titration.

  • Q : Identity of the metal....
    Chemistry :

    If 31.82 g of a metal oxide reacted with excess carbon and 4.08 L of CO2 formed at 100 C and 1.5 atm what is the identity of the metal

  • Q : Calculate the ph after the addition of naoh....
    Chemistry :

    A 25.0 mL sample of 0.100 M lactic acid (HC3H5O3, pKa = 3.86) is titrated with 0.100 M NaOH solution. Calculate the pH after the addition of the following amounts of NaOH.

  • Q : Determine total pressure in the flask....
    Chemistry :

    The total pressure in the flask was __________ atm. Assume the initial pressure in the flask was 0.00 atm and the temperature upon mixing was 25°C.

  • Q : How much heat will be released....
    Chemistry :

    How much heat will be released when 6.44 grams of sulfer reacts with excess oxygen according to the following equation? Is this reaction endthermic or exothermic? 2S+3O2--> 2SO3 H= -791.4kj

  • Q : No of valence electrons....
    Chemistry :

    In writing the Lewis Structure, when we do not have to worry about electrons distribution in each atom alone, and when we have to assign to each atom its particular no of valence electrons?

  • Q : Calculate the mass of nitrogen dissolved....
    Chemistry :

    Calculate the mass of nitrogen dissolved at room temperature in an 80.0 {rm L} home aquarium. Assume a total pressure of 1.0 {rm atm} and a mole fraction for nitrogen of 0.78.

  • Q : Calculate the final temperature of the solution....
    Chemistry :

    Calculate the final temperature of the solution assuming no heat lost to the surroundings and assuming the solution has a specific heat capacity of 4.18 J/°C · g.

  • Q : Calculate the mass of one atom of helium....
    Chemistry :

    Calculate the mass of one atom of helium (atomic mass=1.01 amu). Calculate the wavelength of this atom if it is traveling at .8c

  • Q : What would the volume of the oxygen be at stp....
    Chemistry :

    A certain mass of oxygen was collected over water when potassium chlorate was decomposed by heating. The volume of the oxygen sample collected was 720. mL at 25.0 oC and a barometric pressure of 755

  • Q : The relative atomic mass of calcium....
    Chemistry :

    Ca(s) + Cl2(g) = CaCl2(s) ΔH = -796 kJ mol-1 What will be the enthalpy change (to 2 significant figures) for the reaction when 4.0 g of calcium metal reacts with chlorine gas at constant pressur

  • Q : Determine the lime and soda ash dose....
    Chemistry :

    Determine the lime and soda ash dose in mg/L as CaCO3 to soften the following water to a final hardness of less than 120mg/L as CaCO3.

  • Q : How many atoms would it take to make the distance....
    Chemistry :

    Approximately how many atoms would it take to make the distance 1 cm from end to end. Round to the nearest whole number, do not include units or commas. do not use scientific notation.

  • Q : Calculate the concentrations of the gases....
    Chemistry :

    At the start of the reaction there are 0.714 mole of H2, 0.984 mole of I2, and 0.886 mole of HI in a 2.20 L reaction chamber. Calculate the concentrations of the gases at equilibrium. 

  • Q : What volume of carbon dioxide is produced....
    Chemistry :

    C3H8(g)+5O2(g) > 3CO2(g)+4H2(g) + O(g) In the combustion of 250g of propane with an excess of hydrogen, what volume of carbon dioxide is produced at 290k and 1.5atm

  • Q : What is the density of li2s in grams....
    Chemistry :

    The crystal structure of lithium sulfide Li2S is pictured here. The edge length of the unit cell is 5.88*10^2pm. What is the density of Li2S in grams per cubic centimeter?

  • Q : Nitric acid by the oxidation of ammonia....
    Chemistry :

    In the manufacture of nitric acid by the oxidation of ammonia, the first product is nitric oxide. The nitric oxide is then oxidized to nitrogen dioxide.

  • Q : Highest specific heat capacity....
    Chemistry :

    Based on the graphs below, which of the following substances has the highest specific heat capacity? Assume each experiment began with 200 g of the substance at 100°C mixed with 500 g of water a

  • Q : Determine density of a block of marble....
    Chemistry :

    What is the density of a block of marble that occupies 238 cm3 and has a mass of 973 g?

  • Q : What is the molar mass of insulin....
    Chemistry :

    A solution of 62.4 g of insulin in enough water to make 1.000 L of solution has an osmotic pressure of 0.305 atm at 25°C. Based on these data, what is the molar mass of insulin?

  • Q : What is the molarity of a solution....
    Chemistry :

    What is the molarity of a solution that contains 36.0g of vitamin B1 hydrochloride (molar mass = 337g/mol) in 190mL of solution?

  • Q : Several antacid formulations....
    Chemistry :

    Magnesium hydroxide is used in several antacid formulations. When it is added to water it dissociates into magnesium and hydroxide ions.

©TutorsGlobe All rights reserved 2022-2023.