--%>

What is repeater

What do you mean by the term repeater?

E

Expert

Verified

A repeater is an electronic device which receives a signal and re-transmits it at a higher level and/or higher power or onto the other side of an obstruction in such a way that the signal can cover longer distances devoid of degradation.

   Related Questions in Electrical Engineering

  • Q : Active and Passive Components Describe

    Describe the terms active and Passive Components in brief.

  • Q : Significance of Cogeneration

    Significance of Cogeneration: It decreases energy costs and green house gas emissions usually by upto two-third. In addition to decreasing in cost, cogeneration too rises resource utilization. It provides major economic and environmental facilities si

  • Q : Find value of load resistance for

    Establish an expression for the loaded overdrive factor that σL, of the transistor in the inverter circuit demonstrated below in terms of the circuit parameters. Determine the minimum allowable value of the load resistance RL when the inver

  • Q : Estimate minimum value of input

    The network demonstrated in figure presents the input of a biomedical amplifier, now the input impedance is seem purely resistive, R and a capacitor, C, is used to block dc.

    Q : Uses of Mutex in the critical sections

    Define the uses of Mutex in the critical sections of a task.

  • Q : What is dcm and its usage Explain what

    Explain what is dcm’s and its usage?

  • Q : Determining internal resistance of

    A battery is joined to a resistive load and a current of 10mA flows by the load along with a voltage drop across this of 10V. While the load resistance is increased by 10 percent the load voltage increases by 1 percent. Determine the internal resistance of the battery

  • Q : What is invertible system Explain the

    Explain the term invertible system?

  • Q : Calculate maximum length of cable when

    A simple transistor buffer is needed to drive a length coaxial cable containing a capacitance of 100pF per meter length. The whole steady-state power dissipation of the buffer should not exceed 250mW and the propagation delay of a pulse transmitted along the cable sho

  • Q : Cost of functional or non functional

    Explain the cost of functional or non functional requirements in embedded system.