What is checksum

What is meant by the term checksum?

E

Expert

Verified

Checksum refers to the error detection mechanism which is used by the higher layer protocol. Checksum is based upon the concept of the redundancy.

   Related Questions in Electrical Engineering

  • Q : Find out drift current flowing by

    Find out the whole drift current flowing by a piece of homogenous n-type semiconductor, consisting of a uniform cross-sectional area of 5x10-4 cm2 and a doping concentration of 1016 cm-3, within the influence of electric fie

  • Q : Estimate your personal Annual Energy

    Estimate your personal Annual Energy Usage for the following - list all data in kWh (KiloWatt hours): Space Heating (Central heating, room heaters etc.- if you share a central system, e.g. in a flat or Hall, estimate your personal use). Space cooling (if you have air condi

  • Q : Effect of quantization over the pole

    Explain the effect of quantization over the pole location?

  • Q : Find out impedance in form of phase and

    Find out the impedance of the network demonstrated below as considered by the voltage source, V1, while operating at a frequency of 50Hz. Illustrates this in the form of phase and magnitude. In addition, determine the current drawn from the source by the ne

  • Q : Define Cogeneration Cogeneration is a

    Cogeneration is a very high efficiency energy system which generates both electricity (or mechanical energy) and valuable heat from the single fuel source. Cogeneration is some times termed as combined heat and not only produces power however also giv

  • Q : Illustrates the task and Task state

    Illustrates the task and Task state?

  • Q : Propagation of light along optical

    Explain the various modes for the propagation of light along the optical channels.

  • Q : Synchronizing inverter using a

    I need some help with a project that I am doing. I am asked to make an inverter that can synchronise itself with a local power supply. The only information provided by my project supervisor was as follows: 1. Look at a method of cr

  • Q : What do you mean by stop band What do

    What do you mean by stop band? Briefly describe the term.

  • Q : Find out voltage across and current by

    Determine a Thevenin and a Norton Equivalent Model for the circuit demonstrated in figure given below. Find out, using the models, the voltage across and the current by the load resistance that is RL, and the power consumed through the load. Verify both models present

©TutorsGlobe All rights reserved 2022-2023.