--%>

Problem related to the value of the manometer

Water flows via a pipe of about 300 mm diameter at the rate of 66 L/s. Evaluate the value of the manometer reading, ‘h’. The Specific gravity of manometer liquid is taken as 0.8.

 

816_manometer.jpg

   Related Questions in Mechanical Engineering

  • Q : Problem on pressure rise of a water tank

    The water level in a tank is about 20 m above the ground. A hose is joined to the bottom of the tank, and the nozzle in the end of the hose is pointed to straight up. The tank is at sea level, and the water surface is open to the environment. In the line leading from

  • Q : Arena simulation Are you able to modify

    Are you able to modify the attached [HW4-4-1sawModifiedInstructorTemplate] with the information below for this assignment? Modify the attached exercise by adding agent breaks. The 16 hours are divided into two 8-hour shifts. Agent

  • Q : Difference between mill and mill-drill

    Difference between mill and mill-drill: Nowadays numerous manufactures are combining machines; a mill-drill is one of such. This is a combination of a drill and a mill, a mill eliminates stock from material (genera

  • Q : Bernoulli's equation From Bernoulli's

    From Bernoulli's equation we know that presure head + velocity head at inlet and outlet header is same. If so  what is ' W' then in the equation ?

  • Q : Efficient use of waste heat and

    Efficient use of waste heat and renewable heat sources 1. Describe how you might recover heat from (a) a process exhaust gas stream (e.g. from an oven) and (b) a process warm water stream (e.

  • Q : Problem on motion of the system (a) A

    (a) A plane moving at a constant velocity, V, crashes into a building as shown in figure below. Due to the design against plane crash of that building, neither major damage nor explosion occurs but the building vibrates after the crash. Assuming that the building can

  • Q : Unilateral and Bilateral Tolerance

    Explain difference between the Unilateral and Bilateral Tolerance?

  • Q : Mechanical Systems Reliability -

    Mechanical Systems Reliability, MP3701 Your assignment must be submitted electronically via eLe

  • Q : Problem on damping coefficient Vertical

    Vertical suspension system of a car can be modeled as single degree of the freedom system. Consider that the car with mass m consists of four shock absorbers with equal stiffness and damping of k and c, corresspondingly: (a) Due to

  • Q : Solar Thermal systems Explain the two

    Explain the two Solar thermal DHW and Solar DHW Solar thermal systems n brief?