--%>
Assignment Help - homework help

Priority modes in 8259

Specify various priority modes in 8259?

E

Expert

Verified

a) Special fully nested mode

b) Fully nested mode

c) Rotating Priority mode

d) Special Masked mode

e) Polled mode

   Related Questions in Electrical Engineering

  • Q : Calculate the percentage change in the

    n-channel MOS transistors include the given properties:   Substrate Doping Concentration, NA= 2x1016 cm-3 Metal Fermi Potential, φFM = 0.6 V

  • Q : Illustrates the steps in embedded

    Illustrates the steps in embedded system design? Answer: In embedded system there is need of following term: Requirements, Speci

    		•
  • Q : Estimate maximum tolerable load

    In the capacitively loaded individual transistor inverter demonstrated below, the input voltage is switched abruptly from VCC to 0Volt at time t = 0. In that case the transistor is assumed to function as an ideal change, draw the waveform of the output volt

    		•
  • Q : Estimate your personal Annual Energy

    Estimate your personal Annual Energy Usage for the following - list all data in kWh (KiloWatt hours): Space Heating (Central heating, room heaters etc.- if you share a central system, e.g. in a flat or Hall, estimate your personal use). Space cooling (if you have air condi

    		•
  • Q : Find out secondary voltage and number

    A step-down transformer that operating from a 50Hz mains supply of 220 Volt rms, is used to give a decrease voltage to a secondary power supply. The final delivers 400 Watt of power to a load consisting of an equivalent resistance of 10?. The transformer should have a

    		•
  • Q : Size of inverters Explain the

    Explain the phenomenon of gradually increasing the size of the inverters in the buffer design while trying to run high capacitive load? Why not provide the output of circuit into one large inverter?

    		•
  • Q : Problem on combinational logic design

    Design and analysis of an IC adder built using discrete  logic and a dedicated adder using Integrated Circuits  a) Design a full adder using logic gates. In the design process show truth tables, karnaugh maps and other material used to derive the

    		•
  • Q : Define scheduling and scheduling policy

    Define scheduling and scheduling policy.

    		•
  • Q : DIGITAL SIGNAL PROCESSING Explain the

    Explain the addressing modes which are supported by the C5X processors

    		•
  • Q : Merits and demerits of bus

    What are merits and demerits of I2C (bus interface/bus protocol)?

    		•