--%>
Assignment Help - homework help

Methods used for CMOS to TTL interface

List some of the methods that are used for CMOS to TTL interface?

E

Expert

Verified

Some of these methods that are used for CMOS to TTL interface are listed as follows:

a) By using a CMOS buffer.

b) By giving supply voltage at 5V.

c) By open drain interface

d) By giving different supply voltages.

   Related Questions in Electrical Engineering

  • Q : Networking Homework Help >> Question >>

    Homework Help >> Question >> Address allocation and flow mapping assignment Any questions that are completed should be explained and given a general reason to why that strategy was used. Address allocation is already done and flow mapping is already completed. I just need Q2, Q4, Q5, Q6, Q7, Q8,

    		•
  • Q : Define CMRR of recording system and

    The instrumentation amplifier demonstrated below is to be used such as the front-end phase of an ECG recording system. The ECG electrodes consist of a nominal impedance of 20k, along with a mismatch of up to 5k among them. All of the operational amplifiers include a m

    		•
  • Q : What is ECL RAM Explain the term ECL

    Explain the term ECL RAM. Briefly describe what you mean by this.

    		•
  • Q : Find out reactance of values of

    Find out the reactance of the values of capacitor at the frequencies given below. Then find out the value of inductor in each case that will provide similar reactance as the capacitor as follows:. (a)  3.3 µF at 50Hz

    		•
  • Q : Frequency sampling method for

    Explain the principle of designing the FIR filter using the method of frequency sampling? Specify for what kind of the filters frequency sampling method is appropriate?

    		•
  • Q : Operations performed on signal Explain

    Explain the operations which are performed upon the signal?

    		•
  • Q : Analog and Digital filters Explain the

    Explain the difference between analog and digital filters.

    		•
  • Q : Voltage for transmission and

    (a) Explain the criterion for selection of voltage for transmission and distribution.(b) Describe principle of carrier current protection and communication.

    		•
  • Q : One shots Draw both the expected and

    Draw both the expected and practical output waveforms for the 555 one-shot relative to the trigger-input pulse. Draw the expected and practical output waveforms for the 555 timer in astable mode.

    		•
  • Q : Methods used for CMOS to TTL interface

    List some of the methods that are used for CMOS to TTL interface?

    		•