--%>
Assignment Help - homework help

Flags supported by 8051 controller

Explain the flags which are supported by the 8051 controller?

E

Expert

Verified

a) Carry flag
b) Over flow flag
c) Auxiliary carry flag
d) General purpose user flag
e) Register bank select bit one
f) Register bank select bit zero
g) Parity flag

   Related Questions in Electrical Engineering

  • Q : Determine the values of all tools of

    A buffer circuit is needed to drive the piezoelectric buzzer within a door alarm system. The door mechanism gives a TTL logic well-matched output signal. The buzzer operates from a 12Volt supply and consists of an equivalent load resistance of 80 as well as a small am

    		•
  • Q : What is Time Measurement Explain the

    Explain the term Time Measurement? Also specify some of the instruments to measure the time period.

    		•
  • Q : Addressing modes of 8051 Explain

    Explain various addressing modes of 8051?

    		•
  • Q : What is component testing What is meant

    What is meant by the component testing?

    		•
  • Q : What is invertible system Explain the

    Explain the term invertible system?

    		•
  • Q : Illustrates any two utilizes of VLSI

    Illustrates any two utilizes of VLSI designed circuits?

    		•
  • Q : Calculate phase-gain margins An

    An operational amplifier contains an open-loop transfer function explained as: A(?) = (A0 (1 - j?τ2))/((1 + j?τ1)(1 + j?τ3)) Here:

  • Q : Calculate minimum value of input

    The network demonstrated in figure below shows the input of a biomedical amplifier, here a capacitor, C, is utilized to block dc and the input impedance is taken as purely resistive, R.

    Q : Determine an expression for the loaded

    For the loaded base overdrive factor determine an expression, σL of the transistor within the inverter circuit demonstrated below in terms of the circuit parameters. So, write the expression within terms of the unloaded overdrive factor of it, σ

    		•
  • Q : Analysis on Wireless Technology 4. When

    4. When the bit rate of a message signal from the message sequence generator and the bit rate of a PN code from the multiple sequence generators are compared, which is higher? How did you compare them? Could you determine by how much the bit rate of one is higher?

    		•