Energy and power signal
Explain the term energy and power signal?
Expert
Energy signal : Signal is also known as the energy signal, if and only if the total energy of signal satisfies the condition 0<E<∞.
The total energy of the continuous time signal x(t) is given as:
E=limT→∞∫x2 (t) dt, integration limit from –T/2 to +T/2 Power signal : Signal is known as the powered signal if it satisfies the condition 0<P<∞.
The average power of the continuous time signal is given by:
P=limT→∞1/T∫x2 (t)dt, integration limit is from-T/2 to +T/2.
Illustrate the difference between the SCR and diode rectifier?
Draw both the expected and practical output waveforms for the 555 one-shot relative to the trigger-input pulse. Draw the expected and practical output waveforms for the 555 timer in astable mode.
An operational amplifier contains an open-loop transfer function specified as: A(?) = 104/([1 + j(?/31.4x106)][1 + j(?/314x 106)]) The op-amp is
Explain the phenomenon of gradually increasing the size of the inverters in the buffer design while trying to run high capacitive load? Why not provide the output of circuit into one large inverter?
Differentiate between the terms Angle modulation and Amplitude modulation.
Explain the software timer.
A buffer circuit is needed to drive the piezoelectric buzzer within a door alarm system. The door mechanism gives a TTL logic well-matched output signal. The buzzer operates from a 12Volt supply and consists of an equivalent load resistance of 80 as well as a small am
Explain the term CRC generator.
In the individual transistor inverter circuit demonstrated below, the input voltage is switched abruptly by Vcc to 0V. There base current as acquired from the Charge Control equations governing turn-off of the transistor is specified as:
Explain SISO system and MIMO system?
18,76,764
1929293 Asked
3,689
Active Tutors
1451560
Questions Answered
Start Excelling in your courses, Ask an Expert and get answers for your homework and assignments!!