--%>
Assignment Help - homework help

Calculate the radius of the former of a relay coil

The coil of a relay has 3000 turns wound upon a former having a metal core of relative permeability 8000 and is fed along with a current of 250mA. If the coil have to produce a total internal flux of 0.5Wb and the former include a length of 8cm, calculate the radius of the former needed.

   Related Questions in Electrical Engineering

  • Q : Estimate phase and gain margins of

    An operational amplifier contains an open-loop transfer function specified as: A(?) = 104/([1 + j(?/31.4x106)][1 + j(?/314x 106)]) The op-amp is

    		•
  • Q : Define the ways of communication for a

    Define the ways of communication for a device?

    		•
  • Q : Merits and demerits of bus

    What are merits and demerits of I2C (bus interface/bus protocol)?

    		•
  • Q : Find current in conductor of permanent

    The pole faces of a permanent magnet measure 100 millimeter high by 200mm wide. This is needed to acquire an acceleration of 10ms-2 of a single length of current-carrying conductor that weighs 250gm-1 and is positioned vertically inside the magnetic field, passing horizontal

    		•
  • Q : Benefits of negative feedback over the

    Write down some of the benefits of negative feedback over the positive feedback.

    		•
  • Q : Define Cogeneration Cogeneration is a

    Cogeneration is a very high efficiency energy system which generates both electricity (or mechanical energy) and valuable heat from the single fuel source. Cogeneration is some times termed as combined heat and not only produces power however also giv

    		•
  • Q : Propagation of light along optical

    Explain the various modes for the propagation of light along the optical channels.

    		•
  • Q : Networking Homework Help >> Question >>

    Homework Help >> Question >> Address allocation and flow mapping assignment Any questions that are completed should be explained and given a general reason to why that strategy was used. Address allocation is already done and flow mapping is already completed. I just need Q2, Q4, Q5, Q6, Q7, Q8,

    		•
  • Q : Determine the Binary Numbers into

    Change the given Binary Numbers into decimal form as follows: a. 11011001 b. 11010011100110 Please determine the solution of given problem.<

    		•
  • Q : Find out secondary voltage and number

    A step-down transformer that operating from a 50Hz mains supply of 220 Volt rms, is used to give a decrease voltage to a secondary power supply. The final delivers 400 Watt of power to a load consisting of an equivalent resistance of 10?. The transformer should have a

    		•