What is power factor
Explain the term power factor? Specify whether it is high or low and why?
Expert
Power factor must be high for getting the smooth operation of system. Low power factor states that losses will be more. It refers to the ratio of true power to the apparent power. It has to be ideally 1. If it becomes too low then overheating of cable and equipment overloading will takes place and If it becomes greater than 1 then load will act as capacitor and starts feeding source and will results in tripping.
Specify the properties of system?
A buffer circuit is needed to drive the piezoelectric buzzer within a door alarm system. The door mechanism gives a TTL logic well-matched output signal. The buzzer operates from a 12Volt supply and consists of an equivalent load resistance of 80 as well as a small am
Explain the way to design for upgradeability.
The pole faces of a permanent magnet measure 100 millimeter high by 200mm wide. This is needed to acquire an acceleration of 10ms-2 of a single length of current-carrying conductor that weighs 250gm-1 and is positioned vertically inside the magnetic field, passing horizontal
Explain the various models used into the design of an embedded system?
Describe the type essential units in an Embedded System?
Define the term CAN bus its used?
an example of a c++ program using finite difference method usin boundary value problam
Illustrates the various types of memory within embedded systems? Answer: Different parts in embedded system are illustrated below: Q : Define the requirements for an embedded Define the requirements for an embedded system? Answer: Before designing an embedded system, it should to understand that what has to be designed. It can be identifi
Define the requirements for an embedded system? Answer: Before designing an embedded system, it should to understand that what has to be designed. It can be identifi
18,76,764
1938121 Asked
3,689
Active Tutors
1425491
Questions Answered
Start Excelling in your courses, Ask an Expert and get answers for your homework and assignments!!