Three major types of reinforcement used in pre-stressing
What are the three major types of reinforcement used in pre-stressing?
Expert
Reinforcement of anchor blocks in pre-stressing works comprises:
a) Bursting reinforcement b) Equilibrium reinforcement c) Spalling reinforcement Bursting reinforcement is required wherever tensile stresses are induced. For equilibrium reinforcement, it is required whenever there are a number of anchorages in which pre-stressing loads are applied one after another.
During pre-stressing, spalling stresses are produced in the region at the back of the anchor blocks loaded faces. At the area between two anchorages, there is an amount of concrete enclosed by compressive stress trajectories. Forces are produced in the opposite direction to the applied forces so in turn the generated force pushes the concrete out of the anchor block.
Explain the effect of clearance over the performance of air compressor?
Write about “Timber – in construction”.
Explain the procedure for the formation of the cement?
Why Compounding is required in the steam turbines?
Write brief note on Rotary Compressor.
State the applications of Centralized Air Conditioning?
Please answer Question 1 to 4 (see attached photos)
Which of the air standard cycle (Otto/ Diesel/ Dual) is more efficient for the same heat input? Justify your answer.
Write down the basic requirements of the fuel injection system of Diesel Engine.
In wind tunnel test, why are similarity of Reynolds Number between real bridge and model is often neglected?
18,76,764
1953928 Asked
3,689
Active Tutors
1416574
Questions Answered
Start Excelling in your courses, Ask an Expert and get answers for your homework and assignments!!