--%>
Assignment Help - homework help

Explain VRC

Explain the term VRC.

E

Expert

Verified

Most common and least expensive phenomenon for the detection of error involves the vertical redundancy check (VRC) often known as the parity check. Within this technique, a redundant bit known as a parity bit, is added to the every data unit so, that all number of 0's in total within the unit also including the parity bit, becomes even.

   Related Questions in Electrical Engineering

  • Q : Avalanche breakdown introduction What

    What do you mean by the term Avalanche breakdown? Describe in brief.

    		•
  • Q : Program to transfer data from memory

    Write out the assembly language program in order to transfer the data from the memory block B1 to the memory block B2?

    		•
  • Q : What is figure of merit Describe the

    Describe the term figure of merit?

    		•
  • Q : What is NOR flash Explain the term NOR

    Explain the term NOR Flash? Describe in detail.

    		•
  • Q : Find out impedance in form of phase and

    Find out the impedance of the network demonstrated below as considered by the voltage source, V1, while operating at a frequency of 50Hz. Illustrates this in the form of phase and magnitude. In addition, determine the current drawn from the source by the ne

    		•
  • Q : Combinational circuits devices I have

    I have some problem related to Combinational circuits devices. Answer the following questions in brief. A) Interpret manufacturers’ data sheets to select appropriate combinational logic devices for specific p

    		•
  • Q : Illustrate briefly the term resistor

    Illustrate briefly the term resistor?

    		•
  • Q : Estimate minimum value of input

    The network demonstrated in figure presents the input of a biomedical amplifier, now the input impedance is seem purely resistive, R and a capacitor, C, is used to block dc.

    Q : Compute the minimum CMRR in op-amps The

    The instrumentation amplifier demonstrated below is used to monitor the human ECG. Common-mode interference is present that has amplitude 20 times which of the ECG signal. Compute the minimum CMRR needed in the op-amps used when the maximum error in the signal at the

    		•
  • Q : Find value of load resistance for

    Establish an expression for the loaded overdrive factor that σL, of the transistor in the inverter circuit demonstrated below in terms of the circuit parameters. Determine the minimum allowable value of the load resistance RL when the inver

    		•