--%>
Assignment Help - homework help

Controllability and Observability

What is meant by Controllability and Observability?

E

Expert

Verified

Controllability refers to the capability to establish the specific signal value at every node within the circuit by setting the valves on the input of the circuit.

Observability refers to the capability to measure the signal value at any node within a circuit by controlling the inputs of the circuit and observing its outputs.

   Related Questions in Electrical Engineering

  • Q : Masking 0th and 7th bit by using 8051

    Write a program in order to mask 0th and 7th bit by using the 8051?

    		•
  • Q : What is priority resolver Explain the

    Explain the term priority resolver?

    		•
  • Q : Find out the value of phase for values

    For the electrode amplifier interface model outlined within given figure, illustrate that the maximum phase shift introduced within a signal at the amplifier interface happens at a frequency equivalent to the geometric mean of the pole and zero frequencies as √(

    		•
  • Q : What is regenerative braking Explain

    Explain the term regenerative braking?

    		•
  • Q : Analog signal processing Write down in

    Write down in brief regarding the term Analog signal processing.

    		•
  • Q : Disadvantages of optical fiber State

    State few disadvantages of the optical fiber as the transmission medium?

    		•
  • Q : Determining internal resistance of

    A battery is joined to a resistive load and a current of 10mA flows by the load along with a voltage drop across this of 10V. While the load resistance is increased by 10 percent the load voltage increases by 1 percent. Determine the internal resistance of the battery

    		•
  • Q : Hold and Halt states of 8085

    Explain hold and halt states of the 8085 microprocessor.

    		•
  • Q : Indirect Grid Connection & battery bank

    Large-scale use of wind power raises many questions in integration into the existing electric power grid. Wind power is an intermittent energy source which must be used when available. If a large fraction of a system's energy is to come from wind power, provisions must be made to supply load duri

    		•
  • Q : Problem on electric power The sketch

    The sketch illustrates a common consumer product termed as Water Pik. This device uses a motor to drive a piston pump that produces a jet of water (diameter d = 3 mm, temperature T = 10 °C) with a speed of 25 m/s. Find out the minimum electric power in watts which is needed by the device.

    		•