Analog signal processing

Write down in brief regarding the term Analog signal processing.

E

Expert

Verified

Analog signal processing is for signals which have not been digitized, as in the classical radio, telephone, radar and television systems. This includes linear electronic circuits like passive filters, active filters, integrators, additive mixers and delay lines. It as well includes non-linear circuits like compandors, multiplicators (that is, frequency mixers and voltage-controlled amplifiers), voltage controlled filters, voltage controlled oscillators and phase locked loops.

   Related Questions in Electrical Engineering

  • Q : Problem on electric power The sketch

    The sketch illustrates a common consumer product termed as Water Pik. This device uses a motor to drive a piston pump that produces a jet of water (diameter d = 3 mm, temperature T = 10 °C) with a speed of 25 m/s. Find out the minimum electric power in watts which is needed by the device.

  • Q : Find out impedance in form of phase and

    Find out the impedance of the network demonstrated below as considered by the voltage source, V1, while operating at a frequency of 50Hz. Illustrates this in the form of phase and magnitude. In addition, determine the current drawn from the source by the ne

  • Q : Size of inverters Explain the

    Explain the phenomenon of gradually increasing the size of the inverters in the buffer design while trying to run high capacitive load? Why not provide the output of circuit into one large inverter?

  • Q : What are the examples of functional

    What are the examples of functional requirements?

  • Q : Find coefficients with evaluating

    A Wheatstone bridge based pressure transducer includes a transfer characteristic specified by the relationship as given below:

    Vout = bp + cp2

    Here p is the input pressure applied to the transducer that is calibrated for end point accuracy. So, the transducer

  • Q : Operating mode 2 of 8051 serial port

    Specify the operating mode 2 of the 8051 serial port?

  • Q : Determining internal resistance of

    A battery is joined to a resistive load and a current of 10mA flows by the load along with a voltage drop across this of 10V. While the load resistance is increased by 10 percent the load voltage increases by 1 percent. Determine the internal resistance of the battery

  • Q : Report on designing and simulating a

    Objective: To present a consultant report for designing and simulating a control system.

    Define a practical engineering plant which would feature similar dynamical behaviour to the theoretical dynamics given in the

  • Q : Explain Programmable Intelligent

    What is a Programmable Intelligent Computer?

  • Q : Importance of TXD and RXD pins in 8051

    State the importance of the TXD and RXD pins within the 8051?

2015 ©TutorsGlobe All rights reserved. TutorsGlobe Rated 4.8/5 based on 34139 reviews.