Question 2 doping is a process of adding impurity atoms to

Question

QUESTION 1. Copper is a good conductor.
True
False

QUESTION 2. Doping is a process of adding impurity atoms to an intrinsic crystal to alter its electrical conductivity.
True
False

QUESTION 3. You can quickly check the condition of a diode with an ohmmeter on a high resistance range.
True
False

QUESTION 4. The letter Q is an abbreviation for quiescent, which represents the AC signal is operating between cut-off and saturation points of the transistor.
True
False

QUESTION 5. The half-wave rectifier has a diode in parallel with a load resistor.
True

False

QUESTION 6. In an NPN transistor, the emitter and collector are both n-type materials.
True
False

QUESTION 7. The dc beta is also known as the current gain because a small base current controls a much larger collector current.
True
False

QUESTION 8. The load line is a visual summary of all the possible transistor operating points.
True
False

QUESTION 9. With the switch in the position as shown in Figure 1 below, the LED is on.

figure 1

True or False

QUESTION 10. A transistor can be tested using an ohmmeter to check back and front resistances of emitter-base, collector-base, and collector-emitter.
True

False

QUESTION 11. Hard saturation refers to any design that makes the saturation current gain approximately:
1
10
100
1000

QUESTION 12. While testing a transistor with an ohmmeter, a high reverse/forward resistance ratio for the emitter-base and base-collector junctions indicates

this transistor is good.
this transistor is open and should be replaced.
this transistor is shorted and should be replaced.

this transistor is a small-signal amplifier.

QUESTION 13. A major advantage of an optocoupler is the:

electrical isolation between input and output circuits.
electrical connection between input and output circuits.
higher gain.

low cost of manufacturing the device.

QUESTION 14. With normal circuit operation, Vout in Figure 2 is ________.

Approximately 0V
115 Vac
20 V
10 V DC

QUESTION 15. If the 115 V ac is removed from the circuit shown in Figure 2, what would be measured at Vout?

approximately 0 V

115 V
20 V

10 V

QUESTION 16. What type transistor connection is shown in Figure 3 below?

common emitter
common collector
common base

emitter follower

QUESTION 17. What is the device that increases a transistor's power rating by reducing the internal heat faster?

heater wire
chassis
grommet
heat sink

QUESTION 18. Another name for diode offset voltage is:

barrier potential
ripple voltage
surge voltage
filtered voltage

QUESTION 19. The second approximation of a silicon diode is basically the:

the diode appears as a switch in series with a barrier potential of 0.7 V
the diode appears as a switch in parallel with a barrier potential of 0.7 V
the diode appears as a barrier potential of 0.4 V

the diode appears as a short circuit

QUESTION 20. What is the most popular and useful semiconductor material?

Silver
Copper
Aluminum

Silicon

QUESTION 21. Refer to Figure 4 below.

What is the Peak secondary voltage?
What is the peak-to-peak voltage at the filter point considering non-ideal diode?

Attach file

QUESTION 22. For the CE circuit shown in Figure 5 below, draw the dc load line and mark the dc working point on it. Assume Beta=100 and neglect VBE.
Figure 5