Computer Architecture- MIPS Disassembler
Your project is to write a partial disassembler for MIPS instructions in Java. That is, your input will be the 32-bit machine instructions that a compiler or assembler produces. Your program then figures out what the original source instructions were that created those 32-bit machine instructions and outputs them. The possible source instructions that you must be able to disassemble are: add, sub, and, or, slt, lw, sw, beq, bne. Ignore all other MIPS instructions.
The specific machine instructions that you will disassemble (one after another in this exact order) are: 0x032BA020, 0x8CE90014, 0x12A90003, 0x022DA822, 0xADB30020, 0x02697824, 0xAE8FFFF4, 0x018C6020, 0x02A4A825, 0x158FFFF7, 0x8ECDFFF0
That is, the above 32-bit instructions will be the input to your program. (Eight hex digits are 32 binary bits.) Feel free to embed them in the program itself so you can avoid typing them in each time. Your program will then analyze a 32-bit instruction and figure out what the opcode, register operands and other fields in the instruction are and then print out the assembly language instruction that produced it. Assume that the first instruction begins at address hex 9A040 and the rest follow right after that one. You must output the address along with the instruction.
For example, if your program determines that the first 32-bit machine instruction above is the instruction lw $10, 12 ($20) (it isn't, but if it were) then your output for that instruction would be: 9A040 lw $10, 12 ($20)
You'll then go on and do the next 32-bit instruction, specifying its address in hex (the address for aninstruction immediately following one at 9A040) and what instruction caused those 32-bits. The instruction should show the correct syntax so that an assembler could correctly evaluate it (with the exception of the branch instruction detailed below). Output the numerical registers (e.g., $7, $0) as opposed to the symbolic descriptions (e.g., $s3, $t1). For any load or store instructions, show the offset value as a signed decimal number.
Attachment:- Assignment File.rar