--%>
Assignment Help - homework help

Technology and Engineering

Explain difference between the Technology and Engineering?

E

Expert

Verified

Engineering is defined as the application of science. Technology exhibits several methods of Engineering. A bridge may be formed by utilizing the beams to bear the load through an arc or by hanging in the cable; all displays several technology however comes under civil engineering and science applied includes the laws of force or load distribution.

   Related Questions in Mechanical Engineering

  • Q : Excitation of Modes in Fiber A

    A multimode fiber is used to couple light into a single mode fiber. Both fibers have the same total diameter. Explain the coupling. Use equations, MATLAB, etc. if necessary. If an LED is used to excite a single mode fiber, explain the coupling of light to the fiber? U

    		•
  • Q : Modal Combination Rules What are the

    What are the Modal Combination Rules in order to determine the peak value of the total response?

    		•
  • Q : Define Product Design Specification

    Product Design Specification: Once the basic idea for a product has been made, the next step is to create a product design specification, or PDS. This document must be as comprehensive and as detailed as possible as it forms the basis of all the work

    		•
  • Q : Problem related to mass flow rate Water

    Water flows via a control volume as illustrated in the figure below. At Section (1) the diameter is 40 mm and the velocity profile is given by the V(r) = 10 (4 – r2) m/s, here r is the  distance from the centerline. At Section (2) the mass flow r

    		•
  • Q : Stop cooling-water flow in turbine

    Whether you stop cooling-water flow through steam condenser when the turbine is slopped?

    		•
  • Q : Bearing number ti Diameter of inner and

    Specify how the Bearing number ti Diameter of the inner and outer can be calculated?

    		•
  • Q : Solution A pump station has been

    A pump station has been designed to lift water out of a 6 metre deep pit (vented to atmosphere) via a centrifigual pump mounted at ground level. Liquid conditions 20OC Suction pipe work losses 2.0 metres NPSH safety factor 5.0 kPa Vapor pressure @ 20oC 0.25 metres (a) Calculat

    		•
  • Q : Problem on discharge head loss Water is

    Water is draining from the tank A to tank B. The elevation difference among the two tanks is 10 m. The pipe joining the two tanks has a sudden-expansion section as shown below. The cross-sectional area of the pipe from A is 8 cm2, and the area of the pipe f

    		•
  • Q : Efficient design What is meant by ‘

    What is meant by ‘efficient design’? Explain.

    		•
  • Q : Difference between PLC and Logic Card

    Difference between PLC and Logic Card: There is technically no difference. Both are logic controller utilized for several applications and in PLC has it's own internal memory (compared to Logic card).