--%>
Assignment Help - homework help

Benefits of gear drive

Benefits of gear drive: In general, gear drive is helpful for power transmission among two shafts, which are close to each other (at most at 1m distance). Additionally, it has maximum efficiency while transmitting power. It is resilient as compare to other such as belts chain drives etc. You can amend the power to speed-ratio.

Merits:

  • It is employed to get different speeds in distinct load conditions.
  • It raises fuel effectiveness.
  • Rises engine effectiveness.
  • Require less power input whenever operated manually.  

   Related Questions in Mechanical Engineering

  • Q : Dynamic model for the paper machine

    Explain and derive the Dynamic model for the paper machine headbox?

    		•
  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Stop cooling-water flow in turbine

    Whether you stop cooling-water flow through steam condenser when the turbine is slopped?

    		•
  • Q : Unilateral and Bilateral Tolerance

    Explain difference between the Unilateral and Bilateral Tolerance?

    		•
  • Q : Formation of Cavitation Explain the

    Explain the reason behind formation of the Cavitation in the Centrifugal Pump and not in the Displacement Pump?

    		•
  • Q : Difference between PLC and Logic Card

    Difference between PLC and Logic Card: There is technically no difference. Both are logic controller utilized for several applications and in PLC has it's own internal memory (compared to Logic card).

  • Q : Laws of Thermodynamics Describe all the

    Describe all the laws of the Thermodynamics?

    		•
  • Q : Solution A pump station has been

    A pump station has been designed to lift water out of a 6 metre deep pit (vented to atmosphere) via a centrifigual pump mounted at ground level. Liquid conditions 20OC Suction pipe work losses 2.0 metres NPSH safety factor 5.0 kPa Vapor pressure @ 20oC 0.25 metres (a) Calculat

    		•
  • Q : Convection Heat Transfer Please Solve

    Please Solve this problem Step by step, and the question is in the images.

    		•
  • Q : What is Cotter joint Cotter joint :

    Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both

    		•