--%>
Assignment Help - homework help

Problem on flow rates

Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

965_force on plate.jpg

   Related Questions in Mechanical Engineering

  • Q : Problem related to the value of the

    Water flows via a pipe of about 300 mm diameter at the rate of 66 L/s. Evaluate the value of the manometer reading, ‘h’. The Specific gravity of manometer liquid is taken as 0.8.  

  • Q : What is Cotter joint Cotter joint :

    Cotter joint: These kinds of joints are employed to connect two rods that are under compressive or tensile stress. The ends of rods are in the way of a socket and shaft which fit altogether and the cotter is driven into a slot which is common to both

    		•
  • Q : Bearing number ti Diameter of inner and

    Specify how the Bearing number ti Diameter of the inner and outer can be calculated?

    		•
  • Q : Maintenance in Product design

    Maintenance: How frequently and easily the product is to be maintained must be specified. A photocopier shouldn't require a service call from a technician just to add toner. If the product is to be maintenance free, then costs may be increased due to

    		•
  • Q : Problem on degree of freedom Draw a

    Draw a frequency-response curves for a damped single degree of freedom system subjected to a harmonic excitation under three different damping ratios. System has a natural frequency of ωn as the forcing frequency of the excitation is ω. Describe

    		•
  • Q : Servo drive What do you mean by Servo

    What do you mean by Servo drive and how mechatronic integration approach is improved by it.

    		•
  • Q : Ergonomics in product design

    Ergonomics: This is concerned with how easy (comfort, complexity) the product is to use by the targeted market. Physical human dimensions must be considered when designing the driver's seating, instruments, and controls in a car. Slight variations bet

    		•
  • Q : Efficient design What is meant by ‘

    What is meant by ‘efficient design’? Explain.

    		•
  • Q : Anti-Friction and Journal Bearing

    Explain difference between the Anti-Friction Bearing and the Journal Bearing?

    		•
  • Q : Problem on magnitude of force A

    A horizontal pipe of dimension 540 mm diameter carrying 0.6 m3/s splits into two horizontal pipes of 300 mm diameter with 60% of the flow and another of 150 mm diameter with 40% of the flow. Find out the magnitude and direction of the force