--%>
Assignment Help - homework help

Priority modes in the 8259

Write down the priority modes within the 8259?

E

Expert

Verified

a) Rotating priority mode

b) Fully nested mode

c) Special fully nested mode

d) Special mask mode

e) Poll mode

   Related Questions in Electrical Engineering

  • Q : Use of the IRR Explain use of the IRR

    Explain use of the IRR or interrupt request register?

    		•
  • Q : Estimate phase and gain margins of

    An operational amplifier contains an open-loop transfer function specified as: A(?) = 104/([1 + j(?/31.4x106)][1 + j(?/314x 106)]) The op-amp is

    		•
  • Q : Technique to measure binding of

    Design a technique to measure binding of a collagen binding protein (<25kDa) in the extracellular matrix, in situ. You can assume a finite or infinite tissue thickness. Fully characterize your device, including typical input and output signal amplitudes and design components. Describe a situat

    		•
  • Q : What are the kinds of embedded system

    What are the kinds of embedded system? Answer: The embedded systems are given below: Small scale embedded systems, Medium scale

    		•
  • Q : Find value of load resistance for

    Establish an expression for the loaded overdrive factor that σL, of the transistor in the inverter circuit demonstrated below in terms of the circuit parameters. Determine the minimum allowable value of the load resistance RL when the inver

    		•
  • Q : Explain about the shared data problem

    Explain about the shared data problem.

    		•
  • Q : Propagation of light along optical

    Explain the various modes for the propagation of light along the optical channels.

    		•
  • Q : NAND and NOR gate Explain why NAND gate

    Explain why NAND gate is preferred over the NOR gate for fabrication?

    		•
  • Q : Addition and multiplication of floating

    Explain how the addition & multiplication can be carried out in the floating point arithmetic?

    		•
  • Q : Find current in conductor of permanent

    The pole faces of a permanent magnet measure 100 millimeter high by 200mm wide. This is needed to acquire an acceleration of 10ms-2 of a single length of current-carrying conductor that weighs 250gm-1 and is positioned vertically inside the magnetic field, passing horizontal

    		•