--%>
Assignment Help - homework help

Find out the number of turns of a coil wound on air-filled

A coil wound upon an air-filled former of length 10 centimeter is fed along with a current of 2 Amp. If the coil should produce a magnetic flux density of 0.1 Wbm-2 within the former, find out the number of turns needed.

   Related Questions in Electrical Engineering

  • Q : Real Time Clock (RTC) and Time-out or

    Illustrates the following terms:  Real Time Clock (RTC) and Time-out or Time Overflow?

    		•
  • Q : Define Cogeneration Cogeneration is a

    Cogeneration is a very high efficiency energy system which generates both electricity (or mechanical energy) and valuable heat from the single fuel source. Cogeneration is some times termed as combined heat and not only produces power however also giv

    		•
  • Q : Problem on 4 bit parity generator

    Design of a 4 bit parity generator: a) Using XOR gates design and simulate a 4 bit even parity generator. Draw the circuit in a way to minimize the propagation delay. b) Hence build the ad

    		•
  • Q : Estimate velocity when permeability of

    A conducting coil having 100 turns and consisting of a wound coil diameter of 5cm is to be passed at constant speed throughout a magnetic field into free space to create an induced EMF of 350 millivolt. If the magnetic field strength is 500Am-1, estimate the velocity along with that th

    		•
  • Q : Compute the minimum CMRR in op-amps The

    The instrumentation amplifier demonstrated below is used to monitor the human ECG. Common-mode interference is present that has amplitude 20 times which of the ECG signal. Compute the minimum CMRR needed in the op-amps used when the maximum error in the signal at the

    		•
  • Q : Multifunction displays What is meant by

    What is meant by the multifunction displays?

    		•
  • Q : Block floating point representation

    Explain what block floating point representation is and state its advantages? Specify the benefits of the floating point arithmetic?

    		•
  • Q : Determine the values of all tools of

    A buffer circuit is needed to drive the piezoelectric buzzer within a door alarm system. The door mechanism gives a TTL logic well-matched output signal. The buzzer operates from a 12Volt supply and consists of an equivalent load resistance of 80 as well as a small am

    		•
  • Q : Power-on-Reset in 8051 controller

    Explain the meaning of the Power-on- Reset in 8051 controller?

    		•
  • Q : Report on designing and simulating a

    Objective: To present a consultant report for designing and simulating a control system. Define a practical engineering plant which would feature similar dynamical behaviour to the theoretical dynamics given in the

    		•