--%>
Assignment Help - homework help

Exemplary applications of Small Scale Embedded system

Explain the Exemplary applications of Small Scale Embedded system.

E

Expert

Verified

A long needle rotates elderly minute therefore this 'returns to similar position after an hour. A short needle rotates each hour. Therefore it returns to same position after 12 hours.

There ACVM, Stepper motor controllers for a robotic system, Washing or cooking system and multitasking toys.

   Related Questions in Electrical Engineering

  • Q : Meaning of 3 dB cutoff frequency

    Illustrate the meaning of 3 dB cutoff frequency? Explain why it is3 dB, not 1 dB?

    		•
  • Q : Operating modes of 8255 Explain about

    Explain about the operating modes of 8255?

    		•
  • Q : Schottky TTL and Low power Schottky TTL

    Specify the difference between the Schottky TTL and Low power Schottky TTL? Explain in detail.

    		•
  • Q : Basic Ladder Logic Programming Read

    Read slides 05b spatially from slide 48 to slide 51. Complete signal grapgh on slide 48.

    		•
  • Q : Addressing modes supported by C5X

    Explain the addressing modes which are supported by the C5X processors?

    		•
  • Q : Power plant Draw feed water heating

    Draw feed water heating system in thermal power plant

    		•
  • Q : Problem on Circuit analysis A student

    A student builds the circuit shown below. As it is the circuits contains two major mistakes. Your task is to identify these mistakes and suggest a solution for each. When identifying solutions explain for each case where the mistake is and why the circuit will not wor

    		•
  • Q : Analysis on Wireless Technology 4. When

    4. When the bit rate of a message signal from the message sequence generator and the bit rate of a PN code from the multiple sequence generators are compared, which is higher? How did you compare them? Could you determine by how much the bit rate of one is higher?

    		•
  • Q : Find out drift current flowing by

    Find out the whole drift current flowing by a piece of homogenous n-type semiconductor, consisting of a uniform cross-sectional area of 5x10-4 cm2 and a doping concentration of 1016 cm-3, within the influence of electric fie

    		•
  • Q : Determine expressions for the output HI

    Draw an estimated input-output transfer characteristic for the loaded inverter circuit demonstrated below. Determine expressions for the output HI and LO logic voltages as well as the critical maximum input logic LO voltage ViL max. Obtain an expression for

    		•