--%>
Assignment Help - homework help

chemical flow

I) Sulphur dioxide (SO2) with a volumetric flow rate 5000cm3/s at 1 bar and 1000C is mixed with a second SO2 stream flowing at 2500cm3/s at 2 bar and 200C. The process occurs at steady state. You may assume ideal gas behaviour. For SO2 take the heat capacity at constant pressure to be CP/R = 3.267+5.234x10-3 T

   Related Questions in Chemical Engineering

  • Q : Problem on entropy A heater (heat

    A heater (heat source temperature = 527 K) and turbine are connected in series as shown below:

    Q : Thermodynamics Please can you look into

    Please can you look into this assignment and let me know if its solve able.

    		•
  • Q : Production of ethanol Ethanol (1)

    Ethanol (1) Describe the production of ethanol in Scottish Whisky beverages. Be sure to include a discussion on dangers of impurities (2) Explain the impact of ethanol on the human body (3) List th

    		•
  • Q : Temprature To determine the temperature

    To determine the temperature that occurred in a ?re in a warehouse, the arson investigator noticed that the relief valve on a methane storage tank had popped open at 3000 psig, the rated value. Before the ?re started, the tank was presumably at ambient conditions and the gage read 1950 psig. If

    		•
  • Q : Problem on laboratory solution You are

    You are asked to make up a laboratory solution of 0.10 molar H2SO4 from concentrated (96%) H2SO4 at 56°F. The barometric pressure reads 750 mmHg. You look up the specific gravity of 96% H2SO4 and find it is listed at 1.858. Calculate: (a) th

    		•
  • Q : Problem on heat required for process A

    A steady-state flow process is used to heat methanol in a tank. The incoming stream is at 2 bar and 25 oC and has a flow rate of 5 kg/s. The outgoing stream is at 1 bar, 100 oC. Heating is provided by a heating coil immersed in a tank. Given the

    		•
  • Q : Problem on heat of sublimation Using

    Using the vapor pressure data provided below, estimatei) the heat of sublimation of ice,ii) the heat of vaporization of water,iii) the heat of fusion of ice and compare your estimate with the published value of 6010 J/moLiv) the triple point of wate

    		•
  • Q : Calculating flow rate of nitrogen The

    The feed of an ammonia synthesis reactor is 25% (lbmole) nitrogen with the balance hydrogen. The flow rate is 3000 kg/h at 65°C and 95 bar. Calculate the flow rate of nitrogen to the reactor in kg/hr.

    		•
  • Q : Mass transfer adsorption how to

    how to calculate amount of ammonia adsorbed per kg of adsobent in ammonia calcium chloride adsorption process?

    		•
  • Q : I need to solve the material and energy

    I need to solve the material and energy balance for the att.

    		•