What must be the length of the bar
A 20 mm diameter steel bar is to be used as a torsion spring. If the torsional stress in the bar is not to exceed 100 MPa when one end is twisted through an angle of 15degree, what must be the length of the bar?
Expected delivery within 24 Hours
Assuming that potential and jinetic energy contributions to the overall balance are negligble. Calculate the heat loss from the turbine in KW.
Find the equation P(u, v) of a surface of revolution obtained by revolving a profile curve on the XY-plane about the Y-axis 360.
Molybdenum forms a substitutional solid solution with tungsten. Calculate the concentration (in weight percent) of molybdenum that must be added to tungsten to yield an alloy.
The lift coefficient at this speed is 0.45 and the drag coefficient is 0.065. The mass of the aircraft is 900 kg. Calculate the lift area for the craft, and the requried engine thrust and power.
The studs are made of grade 8 material. Find the torque (in-lb) necessary to tighten to 90 percent of the proof strength, assuming cadmium plated threads.
The second shaft is hollow with an outside diameter of 3 in. and thickness of 0.5 in. and is subjected to a reversed-bending load of 11000 ft-lb. Which shaft will fail first?
Air at 35°C, 105 kPa, flows in a 100 mm × 150 mm rectangular duct in a heating system. The volumetric flow rate is 0.015 m3/s. What is the velocity of the air flowing in the duct and what is the mass flow rate?
A closed tank contains water and heating oil, SG=0.96, and is completely full of the two liquids, with no air space at the top. The tank is being steadily accelerated in the x direction at 1 ft/s2.
A 0.75 m^3 tank contains Nitrogen at 150kPa and 40°C. 2.0 kg of oxygen are added to the tank. What is the final volumetric percentage of the Nitrogen?
Determine the expression for entropy transfer rate accompanying the heat transfer rate over the area from y = 0 to y = L. Assume unit depth into page.
Start Excelling in your courses, Ask an Expert and get answers for your homework and assignments!!