--%>
Assignment Help - homework help

What is critical speed

What is critical speed?

E

Expert

Verified

It refers to the speed at which machine vibrates most violently. It is because of several reasons, like the imbalance or harmonic vibrations which are set up by entire machine. In order to minimize the damage, turbine must be quick through the known critical speed as quickly as possible.

   Related Questions in Mechanical Engineering

  • Q : Bernoulli's equation From Bernoulli's

    From Bernoulli's equation we know that presure head + velocity head at inlet and outlet header is same. If so  what is ' W' then in the equation ?

    		•
  • Q : Problem on displacement response time

    (i) Formulate the equation of motion for the system shown in Figure below. List two assumptions made in this formulation. (ii) Find the response of this system at t = 3s. The system begins with the displacement of 5 cm and velocity

    		•
  • Q : Carburetion A carburetor's primary

    A carburetor's primary function is to mix proper proportions is?

    		•
  • Q : Synchronous generator & Generating units

    Question 1: Three generating units operating in parallel at 60 Hz have rating of 300, 500, and 600    MW and have speed-droop characteristics of 5, 4, and 3%, respectively. Due to a change in load, a

    		•
  • Q : Define spinning jenny Spinning jenny:

    Spinning jenny: It is a multi-spool spinning wheel. It was invented in the year 1764 by James Hargreaves in Stanhill, close to Blackburn, Lancashire in the north west of England (though Thomas Highs is another candidate recognized as inventor).

    		•
  • Q : Ergonomics in product design

    Ergonomics: This is concerned with how easy (comfort, complexity) the product is to use by the targeted market. Physical human dimensions must be considered when designing the driver's seating, instruments, and controls in a car. Slight variations bet

    		•
  • Q : Define Mechanism Mechanism : The

    Mechanism: The mechanism is a system of moving parts which changes an input motion and force into the desired output force and motion.

    		•
  • Q : Preventing the excess discharge pressure

    How we can prevent the excess discharge pressure?

    		•
  • Q : Problem on discharge of water In the

    In the below system, d = 6 in., D = 12 in., Δz1 = 6 ft, and Δz2 = 12 ft. The discharge of water in the given system is 10 cfs. Is the machine a turbine or a pump ? Determine the pressures at points A and B? Neglect head losses. Suppos

    		•
  • Q : Safety in Product design specification

    Safety: The specifications should state the possible abuse and misuse the product might be subjected to. Warning labels and instructions on safe operation of the product should be given. The designer can be held accountable for any accidents that migh

    		•