--%>

Safe turbine operation

For safe turbine operation how many governors are generally required and Why?

E

Expert

Verified

Two independent governors are required for the safe turbine operation. One refers to an over speed or emergency trip that shuts off the steam at 10 percent above the running speed. The second, or main governor, generally controls the speed at the constant rate; though, several applications have variable speed control.

   Related Questions in Mechanical Engineering

  • Q : Bernoulli's equation From Bernoulli's

    From Bernoulli's equation we know that presure head + velocity head at inlet and outlet header is same. If so  what is ' W' then in the equation ?

  • Q : P11 and P12 Pipes Explain difference

    Explain difference between the P11 and P12 Pipes?

  • Q : Positive Displacement Type of Pump

    Explain why the Centrifugal Pump is not known as the Positive Displacement Type of Pump?

  • Q : Problem on basic process of Arena

    Are you able to assist with these two assignments in Arena simulation below? You can use the Basic Process instead of Blocks and Elements.An office of state license bureau has two types of arrivals. Individuals interested in purchasing new plates are chara

  • Q : Benefits of gear drive Benefits of gear

    Benefits of gear drive: In general, gear drive is helpful for power transmission among two shafts, which are close to each other (at most at 1m distance). Additionally, it has maximum efficiency while transmitting power. It is resilient as compare to

  • Q : Define Mechanism Mechanism : The

    Mechanism: The mechanism is a system of moving parts which changes an input motion and force into the desired output force and motion.

  • Q : Powder Technology Explain the term

    Explain the term Powder Technology?

  • Q : Brazing and Welding Differentiate the

    Differentiate the term Brazing and Welding?

  • Q : Problem on flow rates Water flows at 40

    Water flows at 40 m/s from the jet of area of cross-section of 0.008 m2 on to a flat plate as shown in the figure. Determine the force F normal to the plate, and also the flow rates out of the plate.

    Q : Synchronous generator & Generating units

    Question 1: Three generating units operating in parallel at 60 Hz have rating of 300, 500, and 600    MW and have speed-droop characteristics of 5, 4, and 3%, respectively. Due to a change in load, a