On-chip peripherals in 5X

Specify the on-chip peripherals in the 5X.

E

Expert

Verified

The C5X DSP on-chip peripherals available are listed as follows:

a) Clock Generator
b) Software-Programmable Wait-State Generators
c) Hardware Timer
d) Parallel I/O Ports
e) Serial Port
f) Host Port Interface (HPI)
g) Buffered Serial Port (BSP)
h) Time-Division Multiplexed (TDM) Serial Port
i) User-Mask able interrupts.

   Related Questions in Electrical Engineering

  • Q : Estimate phase and gain margins of

    An operational amplifier contains an open-loop transfer function specified as: A(?) = 104/([1 + j(?/31.4x106)][1 + j(?/314x 106)]) The op-amp is

  • Q : Networking Develop traffic flow mapping

    Develop traffic flow mapping and performance requirements for flows.

  • Q : Find out the number of turns of a coil

    A coil wound upon an air-filled former of length 10 centimeter is fed along with a current of 2 Amp. If the coil should produce a magnetic flux density of 0.1 Wbm-2 within the former, find out the number of turns needed.

  • Q : Increasing the clock frequency List out

    List out some of the ways in order to increase the clock frequency?

  • Q : Meaning of half-duplex and full-duplex

    Illustrate the meaning of the term half-duplex and full-duplex communication? Describe in brief. 

  • Q : Find value of channel length modulation

    An n-channel MOS transistor is functioned in the saturation region along with a drain-source voltage of 2V. While the drain source voltage is twice, while keeping the gate-source voltage constant then the drain current increases by 5percent. Find out the value of the channel leng

  • Q : Estimate velocity when permeability of

    A conducting coil having 100 turns and consisting of a wound coil diameter of 5cm is to be passed at constant speed throughout a magnetic field into free space to create an induced EMF of 350 millivolt. If the magnetic field strength is 500Am-1, estimate the velocity along with that th

  • Q : Function of anti-pumping in circuit

    Explain function of the anti-pumping within the circuit breaker?

  • Q : Find out Emitter Saturation and

    An n-p-n transistor contain the given properties are as follows:: Doping Concentrations: Ne = 1018 cm-3, Nb = 1017 cm-3, Nc = 1015 cm-3. 

  • Q : Data mining and data mining techniques

    Explain the term Data mining. Specify different data mining techniques. Also state the aim of Data mining Technique?

©TutorsGlobe All rights reserved 2022-2023.